ASSEMBLY INSTRUCTIONS
Day Bed
-Page 1 of 5-
A1.
Quantity
of 2
A2.
Quantity
of 2
A3.
Quantity
of 2
A4.
Quantity
of 1
Front Leg Rear Leg
A5.
Side Rail
Quantity
of 2
A6.
Slat
Quantity
of 7
Side Frame
Back Frame
B1.
Bolt with washer
Quantity
of 16
B2.
Bolt with washer
Quantity
of 4
B3.
-Page 2 of 5-
Quantity
of 14
B4.
Allen WrenchBolt
Quantity
of 1
Step 1
B1 8sets
B1
B1
B1
B1
Assemble Side Frames A3 to Front Legs A1 & Rear Legs A2 using Bolts B1 with spring washers and flat washers.
(NOTE: Please do not tighten Bolts B1 until Step 5.)
Step 2
B1
B1 4sets
Assemble Back Frame A4 to Rear Legs A2 using Bolts B1 with spring washers and flat washers.
(NOTE: Please do not tighten Bolts B1 until Step 5.)
-Page 3 of 5-
Step 3
A1
B1 4sets
B2 4sets
Fig. 1
Fig. 1
Fig. 1
Step 4
Assemble Rails A5 to Legs A1 &A2 using Bolts B1 & B2 with spring washers and flat washers.
(NOTE: Please do not tighten Bolts B1 & B2 until Step 5.)
B3 14pcs
Do not tighten bolts B3 until Step 5.
-Page 4 of 5-
Step 5
Please tighten all bolts at this point.
Note:Place the bed on the floor and check if it is stable before
tightening all bolts.
Warning:
1). Always use the recommended size of mattress or mattress support to help prevent the likelihood of entrapment
or falls.
2). For your safety do not jump on the bed.
3). The use of water or sleep flotation mattress on the bed is not recommended.
4). The weight load on this bed should never exceed 500lbs. Exceeding this weight limit may cause the bed to
collapse, resulting in serious personal injury and properly damage.
APPENDIX: Dimension of hardware in this AI.
B1
2"L
Ø1/4"
B2
Bolt
5/8"L
Ø1/4"
Spring Washer
Spring Washer
B3
1/2"L
Ø1/4"
Flat Washer
Ø1/4"
Flat WasherBolt
Bolt
Ø1/4"
-Page 5 of 5-
Loading...