
1. At the beginning of each season
and at least twice monthly during
usage, treat ropes with a Teflonbased lubricant.
2. Before each use, check the rope,
knots, support and all connections
for evidence of deterioration,
excessive wear, fractures, breaks or
sharp edges and replace as
necessary.
3. Take tire swing indoors when
the temperature drops below 32
degrees Fahrenheit.
WARNING: Failure to carry out
these checks and inspections could
result in a fall or injury.
NOTE: The color swings fade in
natural condition is normal
phenomenon
1. An adult should supervise play on
this product for children of all ages.
2. Limit: 1 child per swing.
3. Only for family domestic outdoor use
by children 3-8 years old.
4. Dress children appropriately,
including wearing well-fitting shoes
that fully protect the feet.
• Avoid swinging empty seats or swings.
• NEVER swing higher than
• To get off the swing only after it has
completely stopped and to hold the
rope until both feet are planted firmly
on the ground.
• To remove articles before playing on
equipment that create hazards when
they get tangled and caught. Examples
include: ponchos, scarves, and other
loose-fitting clothing, bike or other
sports helmets.
• DO NOT walk close to, in front of,
behind, or between moving items.
Tire Swings
Instruction
For all Tire Swings:
Pooky, Shmoopie, Winky

Installation
1. Do not install tire swing over concrete, asphalt, packed earth, or any other hard surface.
2. Confirm that the supporting structure is secure; it will support at least 200 pounds, is
• Test tree limb to ensure that it will hold the weight limit of 200 lbs. safely.
• Form a small noose at one end of your rope and throw it over the tree limb.
• Run the other end of rope through the noose you created and tighten firmly.
• Run the end of rope through the loop on the tire swing.
• Tie a minimum of TWO tight knots firmly. Bottom of swing should be no less than 8
over level ground, and is no less than 6 ft. from vertical elements on all sides.
inches from ground.
Swing Set or other Horizontal Beam Assembly
Attach the tire swing to a swing set by removing one set of chains from an
existing swing and attach the upper loop (above the PVC separator bar) to the
chain support hook on the underside of the swing set crossbar. Then close the
hook.