Caution : You must read this before you proceed
Page 1 of 6
TABLE
CAUTION: This Table is NOT a TOY.
Keep your child / children at bay during the assembly process.
For moving the Table and to prevent damage to the Table, two adults are needed to execute this
action.
Label Picture Description QTY
Page 2 of 6
A Table Top 1
B Leg 4
C Leg Support 4
Label Picture Description QTY
1
2 Screw (M6x35mm) 9
2
3 Washer 9
3
4
4 Allen Key 1
Bolt (M6x50mm) 9
Before Beginning Assembly:
OVERVIEW
① ③ ④
Repeat the same process with the remaining three Legs(B)
Table Top (A)
Leg Support (C)
Leg (B)
FRONT FACING
This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview
of the Table parts, the above picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
B
3
1
A
Attach Leg(B) to the Table Top(A) using Bolt (①) and Washer(③) with Allen Key(④).
Only loosely tighten the Bolts.
4
Page 3 of 6
Step 3
C
B
A
Page 4 of 6
Step 3.2
2
4
4
2
Step 3.1
Place Leg Support(C) between Table Top(A) and Leg(B), as shown above
3.1) Secure Leg Support(C) to Table Top(A) using Screw (②) with Allen Key(④)
3.2) Secure Leg Support(C) to Leg(B) using Screw(②) with Allen Key(④)
Only loosely tighten the Screws.
Repeat the same process with the remaining three Leg Supports(C).
Step 4
If wobble
Test again
30CM~50CM
Place the Table right side up on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Table to some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Table freely and vertically with the four legs, hitting the ground, at the same time.
This Drop Test will help to ensure that all the Bolts, Screws and gaps all reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, proceed to tighten all the Screws, and Bolts.
CAUTION: When tightening the Screws, and Bolts tighten sequentially. DO NOT tighten any
Bolt, or Screw fully and then move towards the next one. This could cause the frame to warp.
If there are still wobbles, loosen the Screws and Bolts and execute this same drop tests.
If the Table is not stable, it could lead to damage to the product.
Step 5
Page 5 of 6
Inspect Table and make sure all parts are adequately connected.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Page 6 of 6
Loading...