Winstars Technology WS WN518N2 Users manual

WiFi-Repeater

User Manual

Quick Installation Guide(Q.I.G.)

REV.1.2

Introduction：

The WiFi Repeater is a combined wired/wireless network connection device
designed specifically for small business, office, and home office networking
requirements. It allows a wireless network to be expanded using multiple
access points without the need for a wired backbone to link them. It also
works well with other 11b/g and 11n protocol wireless products.

NOTE: If you need to reset the Wi-Fi Repeater, you need press and hold

the reset button inside the tiny hole for 10 seconds.

Package Contents

Before you starting to use this router, please check if there’s anything
missing in the package, and contact your dealer of purchase to claim for
missing items:

• 1 x Wireless-N Repeater

• 1 x RJ-45 Networking Cable

• 1 x Quick installation Guide

Getting Started

Setting up a Wireless Infrastructure Network

For a typical wireless setup at home (as shown below), please do the
following:

Wireless Repeater Mode

You will need WiFi AP/Router
Internet access

Wireless AP Mode

You will need broadband Router
Internet access

Connect the WiFi-Repeater to
your Router/Switch with RJ-45
Cable

How to configure the Wi-Fi Repeater

You can configure the Wi-Fi Repeater by connecting it with your
computer/laptop with enclosed RJ45 cable or wirelessly. We recommend

you to do it with wire.

A. Configure the Wi-Fi Repeater with RJ45 Cable

A1. Plug the Wi-Fi Repeater to a

wall socket. Connect your
computer / laptop with the Wi-Fi
Repeater with enclosed RJ45
Cable.

A2. Click the “

should be located at the lower­left corner of your screen), then
click “

Control Panel

“

View Network Status and

”, and then click “

Tasks
Network Connections

click “

Local Area Network

then select “
the “

Local Area Connection

Properties

select “I

Version 4 (TCP/IPv4)

click “

Properties

A3. Setting IP address manually:

Type IP address is

192.168.10.x (x is from 2 to

), and Subnet mask is

254

255.255.255.0

Router’s LAN IP address (the
default IP is
the Default gateway field.

” button (it

Start

”. Click

Manage

”. Right-

Properties

” window appears,

nternet Protocol

. Type the

192.168.10.1

”. When

” and then

”.

”,

) into

A4. Open web browser and type

http://192.168.10.1 in the

browser's address box. This
number is the default IP
address for this device.

A5. The login screen below will

appear. Enter the “User Name”
and “Password” and click “OK”
to login. The default User name
is “admin” and the Password is
“admin”.

A6. After logging in and click “Setup Wizard”, you will see the web page

below: Select “Wireless Repeater Mode (Station)” and click on
‘Next’ to continue.

A7. Click on ‘Repeater – OneKey Setting’ button

A8. Wait a few seconds and you will see the site below and please click

on ‘Wireless Network Selection’ button.