Winsome house WHF548 Instruction Manual
Product Name:
Peacock
Fountain
w
ith LED Light
SKU #:
WHF548
Instruction Manual
Description
Accessories standards and type
Quantity
01 Fountain
1
02 Pump w/ Adaptor
JEBAO PP
-
333 1
03 Pump cover
1
Thank you for purchasing this Winsome House product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Tools required for assembly: No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Place the fountain on a flat, level surface. From the opening at the back of the fountain base, insert the
water supply tube into the pump outlet. Place the pump upright in the basin and draw the pump power cord
out of the fountain back. (①)
4. Connect the female jack of the pump with the male jack of LED light. Connect the female jack of the adaptor
with male jack of the pump. (②)
5. Add clean water into the basin. The water level should be approximately 30mm lower than the edge of the
basin. (③)
6. Put the pump cover on the pump cover holder on the basin of the fountain. (④)
7. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended. (⑤)
8. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
9. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
10. Check the area around your fountain on a regular basis to ensure that there is no leakage.
11. Please refresh the fountain with water each week to ensure it in good condition.
12. Do not add any harmful chemicals to the water as it may alter the paint finish.
Please save this manual for future reference.
Contact: sales@winsomehouse.com
Product Name:
Peacock
Fountain
w
ith LED Light
SKU #:
WHF548
Instruction Manual
Note: The above diagram is for illustrative purposes only.
Pump Instructions:
Special Warnings and Cautions:
CAUTION:
The pump has been evaluated for use with water only.
Risk of electric shock. Do not remove cord and strain relief. Do not connect conduit to pump.
Do not use the pump in water exceeding 30ºC / 86ºF.
Do not use the pump in flammable liquids.
Do not use the pump for industrial purposes.
Do not use the pump in vehicles or on ships or aircraft or swimming pools.
Do not use the pump in location where special conditions prevail, such as the presence of a corrosive or
explosive atmosphere (dust, vapor or gas).
Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
Do not lift the pump by its power cord.
Keep the plug dry. Do not expose the plug to water or steam.
Before connecting to the power source, make sure that the pump is assembled and completely submerged
in water.
Always disconnect the pump from the power source before performing any maintenance on the pump,
lights (if equipped), or fountain.
Do not exceed the voltage shown on the pump.
Check the water level regularly to ensure the pump is completely submerged during operation. The pump
should be fully submerged during operation. Do not add water while operating the product. Always
disconnect the pump from the power source before adding water.
Please save this manual for future reference.
Contact: sales@winsomehouse.com
Loading...