Quick Start Guide
First s tep: Bluetoo th pairin g
Touch-hold the camera ke y for 3 seconds till the
blue ligh t flashes to show that the Blue tooth is
turned on: pair up with“Dispho”and the blue light
will be on all the t ime if the pai ring is succe ssful.
Touch-hold the camera key for another 3 seconds
to shut Bluetooth down .
Camera button
Second step: open th e phone holder
Set this product face up and turn the phone holder
in the back downward for 90° to open it . Then
rotate the holder 180°horizontally
to face forward.
Third S tep: Fix the phone
Rotate the phone holder till you can pull open the
holder handle and fix the phone securely on the holder.
Fourth Step: Photogra ph
Set the volume button on your phone to act as the
shutter button.
Use the remote contro l to take a phot o.
Fifth S tep: Use tri pod
This pr oduct comes wi th a tripod. O pen the selfi e
holder fr om the bottom and fix it o n a steady
horizon tal plane, then you can star t to enjoy your
selfie shooting experien ce.
Separated Bluetooth remote control is designed t o be
separable with a Bluetooth range of 10 meters.
of the remote control is equipped with a charging
The bottom
port; please use it to charge this pr oduct.
changes or modif ications not expressly approv ed
by the party r esponsible for compliance could void
the user’s authority to operate the equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful in terference in a residential
installation. This equipme nt generates, uses and
can radiate ra dio frequency energy and, if no t
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation.
If this eq uipment does cause har mful interference
to radio or t elevision reception, which can be
determi ned by turning the equi pment off and on,
the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or reloca te the receiving antenna.
-- Increase the separati on between the equipment
and receiver.
-- Connect the equipme nt into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.