Winners Sun Plastic and Electronic WS 19010 User Manual
FCC ID:UR9WS-19010
Quick Guide
The device has been evaluated to meet
general RF exposure requirement, The
device can be used in portable exposure
condition without restriction Federal
Communication Commission (FCC)
Radiation Exposure Statement Power is so
low that no RF exposure calculation is
needed.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) this device may
not cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: The manufacturer is not responsible
for any radio or TV interference caused by
unauthorized modifications or changes to
this equipment. Such modifications or
changes could void the user’s authority to
operate the equipment.
Product description
1
2
3
9
1.Photograph key
2.Indicator light of remote control
3.Handle
4.Mobile phone clip
5.Power output
6.Micro USB charging interface
7.Indicator light of mobile power supply
8.Electric quantity display key
9.1/4 standard screw thread
Bluetooth pairing
Press the photograph key for 3s to enter the Bluetooth
pairing state; open the mobile terminal to enter the
Bluetooth searching state; click “Dispho” in the searching
equipment; after the successful connection, the green
light of the Sele stick is bright.
4
5
6
7
8
Fix the mobile phone
1.Tilt the mobile phone above
the bracket, and push the
mobile phone upwards;
Photograph key
Indicator light
2.Put the mobile phone into
the bracket backwards to
nish the device.
Take photos/ record video
Hold the handle, press the photograph key to take photos/
record video;
Clamp mobile phone 1/3 (as shown in gure)
1/4 standard screw thread (optional)
The bottom of the bracket is provided with 1/4 standard
screw thread; and other products with screw thread can
be selected to match with the 1/4 standard screw thread.
1/4 standard screw thread
Separating remote control
Mobile charging power supply
The product has the function of mobile charging; the mobile
phone can be connected for charging; the electric quantity
can be displayed when short pressing the power key.
Display the electric quantity
for short pressing
Charging method of mobile power supply
When the green light lasts for ashing, please connect
Micro USB interface to charge; the green light ashes
slowly during the charging process; and after the charging
is nished, the four green lights are bright.
Micro USB charging
interface
Replace battery of remote control
Take out the remote control, rotate the remote control to
the back, push the battery cover along the arrow direction,
and take out the battery to be replaced.
1 2 3
Warm prompt
1.The Bluetooth of the remote control is connected; the
stick shall enter the dormant state within 10min
sele
if
there is no operation; and the connection can be
r
ecovered if the photograph key is pressed again.
2.The mobile phone shall be turned off when it is dormant
20min.
for
3.When the remote control is used and the electric quantity
of the battery is not enough, the red light of the remote
control ashes for reminding. Please replace the battery
in time.
Loading...