Winners Sun Plastic and Electronic WS 18026 User Manual

FCC ID:UR9WS-18026

Quick Start Guide

First step: Bluetooth pairing

Long press the Photo button for 2 seconds to enter the
Bluetooth matching state, open the mobile phone to enter
the Bluetooth search state, and click "Dispho" in the search
device to connect successfully, the self-timer stick green
light will be on for a long time.

Camera button

Second step: open the phone holder

Set this product face up and turn the phone holder in the back
downward for 90° to open it. Then rotate the holder 180°
horizontally to face forward.

Third Step: Fix the phone

Rotate the phone holder till you can pull open the holder handle
and x the phone securely on the holder.

Fourth Step: Use tripod

This product comes with a tripod. Open the sele holder
from the bottom and x it on a steady horizontal plane,
then you can start to enjoy your sele shooting experience.

Battery replacement

Take the remote control out, turn the remote control to the
reverse side, and remove its back cover according to the
arrow direction,then the battery can be replaced.

lock

open

Winners' Sun Plastic & Electronics (Shenzhen) Co., Ltd.
Building E, Yingtai Industrial Zone, Longhua New District,
Shenzhen,China.

Federal Communication Commission (FCC) Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement, The device
can be used in portable exposure condition without restriction Federal
Communication Commission (FCC) Radiation Exposure Statement Power is so low
that no RF exposure calculation is needed.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications or changes to this equipment. Such modifications or
changes could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.