Winmate 3500WBW User Manual
Rugged PDA
C350T Series
User Manual (V1.0)
Notes:
All screens in this guide are simulated. Actual displays may be different.
Depend on the different software version on your C350T; you may get different screens with same
tasks.
Unless specified otherwise, all instructions to perform tasks in this guide assume that you are starting
from the home screen.
FEDERAL COMMUNICATIONS COMMISSION
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
RF exposure warning
The equipment complies with FCC RF exposure limits set forth for an uncontrolled
environment.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
RF exposure information (SAR)
This Rugged PDA meets the government's requirements for exposure to radio waves.
This Rugged PDA is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. The exposure standard for wireless Rugged
PDA employs a unit of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using
standard operating positions accepted by the FCC with the Rugged PDA transmitting
at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the Rugged
PDA while operating can be well below the maximum value. This is because the
Rugged PDA is designed to operate at multiple power levels so as to use only the
poser required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output. The highest SAR value for US model
Rugged PDA as reported to the FCC when tested for use at the body, as described in
this user guide, is 0.713 W/kg.
Before starting to use C350T
1) Insert Micro SD / SIM card (Optional)
The built-in storage space of your C350T series PDA is mainly used for operation
system. To enable some functions need bigger storage space, such as camera or
other APP, please insert a Micro SD card before using.
2) Charge the Battery
The battery in your new C350T series device is not charged yet. Please charge with
the bundled USB cable before your first use.
Caution! Please don’t remove the battery pack or try to take this PDA apart
while the C350T is charging. These actions will result in some damages and may
invalidate your warranty.
3) Some tips for using and caring your PDA
Your C350T series PDA is designed to resist damages from certain rugged
conditions. However, to help care for your PDA, please avoid prolonged or extreme
exposure to those conditions.
To ensure the rugged design works and protects your PDA, please be sure
the USB connector cover is closed and the back cover is screwed properly.
Don’t leave your PDA near a heat source; this can damage the device.
Avoid dropping your PDA on a hard surface; this can potentially cause
damage to the device.
To clean your PDA, use a dry soft cloth. Don’t use alcohol or other cleaning
solutions.
Please don’t have your PDA contact with water when the cover is opened.
The water-proof design works only when the outer case is sealed properly.
Note: Certain apps and features may not be available in all countries.
I
C350T Outlook
Function Button
Function Button
Proximity Sensor
Receiver
3.5” Touch Screen
Micro USB Port
(B type)
Microphone
Version for Android OS:
Menu
Home
Back
Version for Windows OS:
Function 1
Start
Function2
Power indicator
Flashing
Green
Power
On/Off
Amber
Charging
Red
Low power
Power Button
Press
Sleep
Hold
Power on / off
Front View (without Barcode / RFID Reader)
II
LED Flash Light
5M Pixel Camera
Speaker
Docking Connector
Stylus
Back View (without Barcode / RFID Reader)
III
Function Button
Function Button
Proximity Sensor
Receiver
3.5” Touch Screen
Micro USB Port
(B type)
Microphone
Version for Android OS:
Menu
Home
Back
Version for Windows OS:
Function 1
Start
Function2
Power indicator
Flashing
Green
Power
On/Off
Amber
Charging
Red
Low power
Power Button
Press
Sleep
Hold
Power on / off
Front View (with Barcode Reader)
IV
Bar Code Reader
Sensor
C350T-BR1 or C350T-BR2
= 1D/2D Barcode Reader
Stylus
Docking Connector
Back View (with Barcode Reader)
V
Key Pad Table:
VI
CONTENTS INDEX
Set up & Go ............................................................................... 1
Power On/Off ............................................................................. 5
Touch Screen and keys ............................................................... 6
Home Screen & Status ............................................................. 12
Set up Language ...................................................................... 16
Set up Date & Time ................................................................. 16
Internet Connection ................................................................ 17
Bluetooth ................................................................................. 19
App Menu ................................................................................ 21
Software Update ...................................................................... 23
Text entry ................................................................................. 24
Messaging ................................................................................ 25
Camera .................................................................................... 26
Photo & Video ......................................................................... 29
SET UP & GO
1. Turn Off the PDA
Make sure the PDA is powered off and the USB cable is un-connected before you
remove the back cover.
Note: Please refer to page 5 for the details scenarios about how to turn off
your C350T PDA under Android OS.
2. Open the Back Cover
Make the PDA facing down, and then unscrew the 2 buckle. Gently pull out the
back cover.
1
3. Remove the Battery
Pull the plastic strap on the battery, and then remove it.
2
Loading...