Winix D480, D360 User Manual

AIR PURIFIER

D480 / D360Model

User Manual

Use & Care
Guide

• ThisproductismanufacturedforuseonlyintheUSAandCanada.

• Thisproductissuitablefor120Vonly.

2 3 4 5 6

MODEL PART DIAGRAM

FRONT

Control Panel

Front Panel

WHERE TO USE

4 in

12~18 in

BACK

Air Outlet
Vent

Handle

Power plug

Allow 12 ~ 18 in. of space between TVs, radios, and other electronics

Electromagnetic interference from certain electronics may cause
product malfunction.

Place indoors away from direct sun light

Direct exposure may cause product malfunction or failure.

Only place on hard, flat surfaces

Flimsy or slanted surfaces may result in abnormal noise and vibrations.

Allow at least 4 in. from walls

For maximum air flow.

CONTROL PANEL

02 04 100706

01 05 08 12

03

01. Smart Sensor

When in Auto Mode, the Smart Sensor detects the
amount of impurities in the environment to adjust fan
speeds.

02. Check Filter Indicator

LED light indicates when it is time to change the filter.

03. Filter Reset Button

After replacing the True HEPA Filter, use a small
object such as a paper clip, to press and hold the reset
button for at least 5 seconds until the Check Filter
light turns off.

04. Auto Mode

The LED "Auto" light will indicate when Auto mode is
activated.

•When in Auto Mode the Fan Speed is automatically
adjusted according to the indoor air quality.
As the indoor air quality improves, the fan speed will
automatically decrease. If the indoor air quality worsens,
the fan speed will automatically increase.

05. Auto Button

•Use the Auto Button to set the Air Purifier to Auto Mode.

06. Air Quality Indicator

Color-coded LED indicates one of three levels of air
quality.

•BLUE (good), AMBER (fair), RED (poor).

07. Fan Speeds

Indicates the current fan speed.

08. Sleep Mode

The LED "Sleep" light will indicate when Sleep mode is
activated. When Sleep mode is activated:

•The Air Quality Indicator LED light is disabled.

•The fan speed is automatically set to quiet.

09. Fan Speed Button

Use the Fan Speed Button to set the desired
Fan Speed. Fan Speeds cycle in this sequence :
Low, Medium, High, Turbo, Sleep, Low.

1109

10. Power Indicator

LED light indicates when the air-purifier is turned on.

11. Power Button

Turns the unit on or off. During the first 30 seconds
of power, the Air Quality Indicator will cycle through
Blue, Amber and Red colors.

•Smart Sensor takes approximately 4 minutes to gauge
the air quality in the environment before normal
operation begins.

3-STAGE AIR PURIFICATION

12. Light Sensor

When in Auto Mode, the light sensor detects when to
put the unit into sleep mode.

•Detects the amount of ambient light in the environment.

1

01. Pre-Filter

Designed to catch larger airborne particles found
indoors.

02. Activated Carbon Filter Sheet

Reduces VOCs and household odors from cooking,
pets, and smoke.

2

Activated Carbon Filter SheetPre-Filter

03. True HEPA Filter

Captures 99.97%* of airborne allergens including;
pollen, Mold spores, dust, pet dander, microbes, and
smoke. *particles as small as 0.3 microns in size.

3

True HEPA Filter

INITIAL OPERATION

Latch

1.

Remove the front panel by grasping its upper edge
and gently pulling forward.

3.

Remove the filters from the protective plastic bag.

2.

Remove the Pre-Filter, then the bag of filters
behind it.

02

01

03

4.

Install the filters until they fit securely in place.

01. Pre-Filter (front)

02. Activated Carbon Filter Sheet (middle)

03. True HEPA Filter (back)

Latch

5.

After filters are installed close the front panel.

6.

Insert the power cord into an electrical outlet.

MAINTENANCE

When to Replace Filters

Filter Indicator Light When to service When to replace

Pre-Filter

Activated Carbon Filter
Sheet

True HEPA Filter

•When the Check Filter indicator LED is on, it is time to replace the True HEPA Filter.

•Intervals between filter replacement may vary depending on environment.

none Clean once every 14 days Permanent

none

Can NOT be WASHED

Replace every 3 months

Lasts Approx.

12 months

D3

D4

•

Contact Winix for
product related inquiries
and customer service

Toexpediteservice,pleasespecifythemodelnameandnumber,thenatureoftheproblem,yourcontact
information,andyouraddress.

Dedicated Call Center :

•

Website : www.winixamerica.com

☎

[phone]

2610-0236-00 Rev.00

2 3 4 5 6

11 10 9 8 7

D3

D4

UNIT SPECIFICATIONS

Model Name

Power Voltage

Power Rate

Verified Room Size

Product Dimensions

Product Weight

Replacement Filter

The exterior, design, and product specifications may be changed without prior notice to improve product
performance.

Warning : Change or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures.

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or on experienced radio/TV technician for help.

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions:

•This device may not cause interference.

•This device must accept any interference, including interference that may cause undesired operation of the device.

16.77 in(W) x 11.81 in(D) x 22.83 in(H) 14.96 in(W) x 10.33 in(D) x 21.06 in(H)

Filter D4 / SKU : 1712-0100-00 Filter D3 / SKU : 1712-0101-00

D480 D360

AC120V/60Hz

90 W 65 W

480 sq.ft. 360 sq.ft.

17.6 lbs 16.6 lbs