WINIADAEWOO DLN 15D3, DLN 17D3, DLN 20D3 Users manual

LCD TELEVISION

INSTRUCTION MANUAL

DLN-15D3SHS
DLN-17D3SHS
DLN-20D3AHS

IMPORTANT

INFORMATION

FCC RF INTERFERENCE STATEMENT

NOTE : This equipment has been tested and found to comply with the limit for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If these equipment does cause harmful interference to radio or television reception which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measure.

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Correct the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio, TV technical for help.

• Only shielded interface cable should be used.

2

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is
intended to alert the user to the presence of uninsulated “dangerous voltage” with­in the product’s enclosure that may be of sufficient magnitude to constitute a risk
electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and servicing instructions in the literature
accompanying the appliance.

IMPORTANT
INFORMATION

WARNING : FCC regulations state that any unauthorized changes or modifications to this equipment not

expressly approved by the manufacturer could void the user’s authority to operate this
equipment. U.S.A. ONLY

Note to CATV system installer : This reminder is provided to call the CATV system installer’s attention to

Article 820-40 of the National Electrical Code that provides guidelines for
proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to the point
of cable entry as practical.

This product utilizes tin-lead solder, and fluorescent lamp containing a small amount of mercury.
Disposal of these materials may be regulated due to environmental considerations. For disposal or
recycling information, please contact your local authorities or the Electronic Industries Alliance :
www.eia.org

3

SAFETY

PRECAUTIONS

The present set has been designed and manufactured to
assure personal safety. Improper use can result in electric
shock or fire hazard. The safeguards incorporated in the
present unit will protect you if you observe the following
procedures in installing, using and servicing. The present
unit is fully transistorized and does not contain any
element that can be repaired by the user.

• Read these instructions : All functional instructions must
be read and understood before operating the product.

• Keep these instructions : It is recommended to keep
these safety guidelines and operating instructions in a
safe place for future reference.

• Heed all warnings : All warnings on the product and in
the instructions must be observed closely.

• Follow all instructions : All operating instructions must
be followed.

• Attachments / Accessories : Only use the attachments /
accessories specified by the manufacturer. Using
inadequate attachments can result in accidents.

• Power source :This product must
operate according to the power
source indicated on the
specification label. If you are not
sure of the type of power supply
used in your home, consult your
dealer or local electric company. For the units designed
to operate on batteries or another power source, refer to
the operating instructions.

• Power cord protection : Protect
the power cord from being
walked on or pinched particularly
at plugs, convenience receptacles,
and the point where they exit from
the apparatus.

• Overloading : Do not overload
AC outlets or extension cords.
Overloading can cause fire or
electric shock.

• Influx of objects and liquids :
Never let objects into the
productthrough vents or openings.
Due to the high voltage flows in the
product, inserting a foreign object
in the product can cause electric
shock and/or shorten internal elements. For the same
reason, be careful not to spill water or other liquids over
the product.

• Servicing : Do not attempt to service
the product yourself. Removing
covers can expose you to high
voltage and other dangerous
conditions. Request a qualified
service person to perform servicing.

• Repair : Unplug the AC cord from
the outlet, and request a qualified
service person to perform repairs
when:

a. The power cord or plug is

damaged.

b. A liquid is spilled on or an object is

dropped into the product.

c. The product has been exposed to

rain or water.

d. The product does not function

properly as described in the
operating instructions. Do not touch
the controls other than those
described in the operating
instructions. Improper adjustment
of controls out of the instructions
can cause damage, which often requires a qualified
technician for extensive adjustments.

e. The product has been dropped or damaged.

f. The product displays an abnormal condition. Any

noticeable abnormality in the product indicates that the
product needs servicing.

4

SAFETY
PRECAUTIONS

• Replacement parts : In case the
product needs certain parts to be
replaced, make sure that the service
engineer uses the replacement
elements either specified by the
manufacturer, or with the same
characteristics and performance as original ones. Using
unauthorized parts can result in fire, electric shock
and/or other danger.

• Safety checks :Upon completion of service or repair
work, request the service technician to perform safety
checks to ensure that the product is in proper operating
condition.

• Polarization : Do not defeat the safety purpose of the
polarized or grounding type plug. A polarized plug has
two blades with one wider than the other. A grounding
type plug has two blades and a third grounding prong.
The wide blade or the third prong is provided for your
safety. When the provided plug does not fit into your
outlet, consult an electrician for replacement of the
obsolete outlet.

Caution : To prevent electric shock, match wide blade of

plug to wide slot, fully insert.

Attention : Pour éviter les choc électriques, introluire la

lame la plus large de la fiche dans la borne
correspondante De la prise et pousser jusqu’au
pond.

• Cleaning : Unplug the AC cord
from the AC outlet before cleaning
the product. Use only with a dry
cloth to clean this apparatus. Do
not use liquid or aerosol cleaners.

• Water and moisture : Do not use
this product near water such as
bathtub, washbasin, kitchen sink
and laundry tub, swimming pool
and in a wet basement. TV set shall
not be exposed to dripping or
slashing and no objects filled with liquids, such as vases,
shall be placed on the TV set.

• Stand : Do not place the product on
an unstable cart, stand, tripod or
table. Unstable installation is likely
to make the product fall resulting in
serious injuries as well as material
damage. Use only the cart, stand,
tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus.

• When a cart is used, use caution
when moving the cart / apparatus
combination to avoid injury from
tip-over.

• Ventilation : The vents and other
openings in the cabinet are
designed for ventilation. Do not
cover or block them since
insufficient ventilation can overheat
and/or shorten the product ’s life
span. Do not place the product on the bed, sofa, rug or
other similar surfaces since they can block ventilation
openings. This product is not designed for built-in
installation; do not place the product in an enclosed
place such as a bookcase or rack unless proper
ventilation is provided or the manufacturer ’s instructions
are followed.

• The LCD panel used in this product is made of glass.
Therefore, it can be broken when the product is dropped
or gets shock. Be careful not to be injured by glass
pieces in case the panel is broken.

• Heat sources :Do not install near
any heat sources such as radiators,
heat registers, stoves, or other
apparatus (including amplifiers)
that produce heat.

• The LCD panel is a product of very high technology with
2,359,296 (15 ”)/ 2,949,120 (17” Wide) thin film
transistors, giving you fine picture details. Occasionally,
a few non-active pixels may appear on the screen as a
fixed blue, green or red point . Please note that this does
not affect your product ’s performance.

5

SAFETY

PRECAUTIONS

6

• As a measure of additional
protection of this television
equipment, unplug this apparatus
during lightning storms or when
unused for long periods of time.
This will prevent the equipment
from being damaged by lightning and power-line
surges.

• Outside antenna system should not be located in the
vicinity of overhead power lines or other electric or
power circuits including the place where it can fall onto
such power lines or circuits. Installing outside antenna
system requires a full care to keep such power lines or
circuits out of reach as it may be fatal to touch them.

• If an outside antenna is connected to television
equipment, be sure the antenna system is grounded so
as to provide some protection against voltage surges
and built-up static charges.
Section 810 of the National Electrical Code provides
information concerning proper grounding of the mast
and supporting structure as well as of the lead-in wire to
an antenna discharge unit, the size of grounding
conductors, the location of antenna-discharge unit, the
connection to grounding electrodes and the requirements
for grounding electrode.

CONTENTS

7

IMPORTANT SAFEGUARDS 5

SUPPLIED ACCESSORIES 6

FUNCTIONAL OVERVIEW 7

Front (Control panel) 7
Remote controller 8

PREPARATION 9

Inserting Batteries into the Remote Control Unit 9
Mains connection 9
Aerial connection 10
Connecting external equipment 12

INSTALLATION 15

Language selection 15
Automatic Tuning of TV Channels 15
Programme Editing 16
Manual Setup 17

DAILY USE 18

Switching On and Off 18
Recall 18
Programme Selection 19
Picture Control 19
Sound Control 20
Special Features 21
Sleep 21
Teletext (Option) 22
PC setup 24

WALL/ARM MOUNTING 26

TROUBLESHOOTING 27

PRODUCT SPECIFICATIONS 28

Supplied

Accessories

8

AC cord AC adapter

123

456

789

RECALL

SLEEP

PC

POWER

VOL VOL

PR

PR

NORMAL

S.MODEASPECT

X

?

MENU

0

Remote controller Instruction manual