Win-Holt INHPL-1836C Service Manual

equipment

winholt

Operational Maintenance

& Service Bulletin for Models:

NHPL-1836-ECOC

Non-Insulated Economy

NHPL-1836C

Non-Insulated Standard

NHPL-1825-UNC

NHPL-1836C

Non-Insulated Universal Runner

NHPL-1810/HHC

Non-Insulated Undercounter 1/2 size

INHPL-1836C

Insulated

NHPL-1825-UNC

100% Pre-Tested Electrical Assembly

N e w Y o r k | P e N N s Y l v a N i a | T e x a s | C a l i f o r N i a | C h i N a

800.444.3595 | 516.921.0538 fax | www.winholt.com

equipment

General Information

Models:

NHPL-1836- ECOC

NHPL-1836C
NHPL-1825-UNC
NHPL-1810/HHC

INPHL-1836C

TABLE OF CONTENTS

General Information ............................................................................................ 1

Unpacking and Installing ................................................................................... 1

Maintenance and Caution .................................................................................. 1

Power Supply ...................................................................................................... 1

Operating Instructions ...................................................................................... 2

Service Specifications ........................................................................................ 2

Recommended Temperature Guidelines-Food holding Chart ....................... 3

Universal Runner Assembly Instructions ........................................................ 6

Statement of Warranty, Claims & Parts ............................................................ 5

Trouble Shooting ................................................................................................ 5

Drawer Assembly ................................................................................................ 4

Electric Schematic Power Supply ..................................................................... 5

winholt

800-444-3595 | fax: [phone] | www.winholt.com

equipment

General Information

The models NHPL-1836- ECOC, NHPL-1836C, NHPL-1825-UNC, NHPL-1810/
HHC and INHPL-1836C Series cabinet will hold food hot at a constant temperature
and supply humidity for proofing when the application applies. This cabinet is NOT a
cooking appliance.

UNPACKING

Examine the interior of the unit to make sure all packing materials are removed
before the unit is plugged into an electrical outlet. Examine the interior and exterior to
determine whether any damage was incurred during delivery. If so, notify the carrier
immediately to file a damage claim. All Win-Holt equipment is carefully tested and
inspected prior to shipment. When accepted for delivery by carrier, the responsibility
for safe arrival at the destination is assumed by the carrier. For the NHPL-1825-UNC,
universal runners are boxed separately and found inside the cabinet.

CAUTION

Should any damage be found, do not attempt to operate the unit. Call your dealer
IMMEDIATELY to arrange for service.

INSTALLATION

Position your unit on a stable level surface and plug in the supplied cord into any
grounded 120-volt AC, 15 amps power supply dedicated breaker. It does not require a
dedicated circuit but is designed for use with the power cord supplied with the unit. It is
highly recommended that you use ONLY the power cord supplied. Use of a dedicated
circuit should insure operational efficiency. Do not operate the unit with an extension
cord.

MAINTENANCE

The equipment has been designed to require minimum maintenance and has been
constructed to meet NSF and U.S. Public Health Service standards.
Non-toxic chemical cleaners or mild detergents are recommended for cleaning of
fixtures. DO NOT use steel wools of any kind. Steel wool particles will work into the
grains of the metal causing corrosion. Also, these particles can cause a health hazard.
Should scouring be required, use a non-abrasive type of cleaner. Do not use caustic
solutions on your equipment. Hosing or steam cleaning should not be necessary to
keep these fixtures clean and sanitary. Do not allow water or steam to come into
contact with electrical components. Never power wash or steam clean the cabinet with
the power drawer inserted.

POWER SUPPLY ( NHPL-PD-ECO for All Models )

The the units do not require a dedicated circuit but is designed for use with the power
cord which is supplied. It is highly recommended that you use ONLY the power cord
supplied. Use of a dedicated circuit should insure operational efficiency. Do not operate
the unit with an extension cord.

CAUTION

Be sure to disconnect power source before cleaning and servicing the unit. Liability
for improper or careless use is the responsibility of the equipment owner or persons
servicing the unit, including the authorized service agent.

www.winholt.com | fax: [phone] | 800-444-3595

winholt

1