Wingman Models IAF TC-2 Trainer Kfir, WMK48011 Assembly Manual

IAF TC-2 Trainer Kfir

Assembly guide

WMK48011

1/48 Scale

Plastic parts

Etched metal parts Paper masking

Transparent
part

Vac-u-formed
canopies

Resin parts

A BD

E

Parts not in use

1

2

3

4

5 5

6

A

D E

F

G H I

J

B C

23

33

34

38

21

22

24

25

26

27

33

29

30

31

32

28

35

Pitot
Nose tip

36

37

AOA probe

Brass parts

15

16

17

K

14

11

14

18

19

10

7

8

9

1312

Do the same for the

opposite side

Use Wingman parts

instead

Drill a hole Photo etch parts.

Glue with Super glue.

Apply decal

Options

Multiple time Painting

Instructions

1 2

3

E

E9

E10

E11

The numbers in
brackets refer to the
other side.

Cut and remove

Cut and remove

Cut and remove

Important:

Remove the kit spine
by cutting in the right
direction (horizontally
NOT vertically), leaving
a small mounting stage,
which is needed for our
resin part .

Cut and remove

2

4

White

D73 (D74)

D1 (D2)

6

D

ICH

( )

( )

Rear seat

5

2

5

8

D4

4

7 7

JCG

D

( )

( )

Front seat

5

4

Mk.10 Ejection Seats

Paint the metal frame of
the Mk.10 ejection seats
Medium Sea Grey Hu 165
with head rest and back
rest cushions in a mixture
of Hu 86 Light Olive and
Hu 155 Olive Drab. The
seat belts are Hu 26 Khaki
with pulls in Hu 155 Olive
Drab. The housing of the
rescue pack is painted
in Hu 99 Lemon. Other
colors in use are Red,
Yellow Hu 24, White, Black
Hu 33.

7

Drill the holes on
both intakes.

3

4

1. Glue the front area
of part to part
number and set
aside to let it dry.

4. Seal and carefully sand the
recess shown in Red.

2. Glue the rear area
and press the part
toward each other.
If in doubt, genly
heat the part for a
few seconds in the
microwave or over
hot water vapors to
t to shape.

1

2

1

2

8

9

D44

D45

7

6

6

3. Remove the area
marked in Red.