Wine racks America Top Horizontal Display Assembly Manual

Top Horizontal Display

Assembly GUIDE

Page 1

Questions?

888.373.6057

or visit

wineracksamerica.com

RAIL SCREWS

Single Deep Double Deep

Package Contents tools for assembly

*Please verify that you have the correct number of parts before proceeding.

Depending on the model you purchased, your bundle should contain the following:

DOUBLE DEEP SIDE PANEL (x2)

TOP PANEL (x1)

WOOD SCREWS FINISH NAILS

WOOD PUTTY

SINGLE DEEP SIDE PANEL (x2)

METAL RODS

DOUBLE DEEP (x32) SINGLE DEEP (x16)

TRIM PIECE (x1)

Required

Wood Glue

Suggested

Cordless Drill

ScrewdriverAllen W rench

Finish Naile r

*Follow the same assembly procedure for all Top Label Out Display models

Ham mer

Nail Setter

Questions?

Top Horizontal Display

Assembly GUIDE

1. Find an open, flat area in which to work. Carefully remove all components from the box and remove any packaging
materials. Check the parts list to verify package contents.

2.

Begin by attaching 4 metal rods into the pre-drilled holes on the four corners of each side piece. Using an allen wrench
or drill, carefully attach each metal screw to the 4 metal rods. Make sure that the metal screws are attached to the side
with the countersunk holes. Do not tighten until ALL metail rods have been attached. Make sure all of the holes
line up evenly. (figure 1)

Page 2

888.373.6057

or visit

wineracksamerica.com

Top

Bottom

3. Attach the remaining metal rods to the side panels using the provided metal screws. (figure 2)
Do not tighten screws until ALL rods have been attached. After they are attached, carefully tighten each metal
screw all the way. *Do not overtighten.

START WITH

1

4 CORNERS

ATTACH REMAINING

2

METAL RODS