Wine racks America Standard Tasting Table Assembly Manual

Standard Tasting Table

Assembly GUIDE

Standard

Connector

End Ladder

End Ladder

Middle Ladder

Page 1

Questions?

888.373.6057

or visit

wineracksamerica.com

Screwless
Connector

Middle Ladder

End Ladder

Package Contents tools for assembly

*Please verify that you have the correct number of parts before proceeding.

Depending on the model you purchased, your bundle should contain the following:

END LADDER (X2)

35 3/4"

MIDDLE LADDER (X7)

35 3/4"

STANDARD 8 COLUMN CONNECTOR (X2)

SCREWLESS 8 COLUMN CONNECTOR (X2)

SOLID TOP (OPTIONAL)

Required

Screwdriver

Suggested

Cordless Drill

Wood Glue

Finish Nailer

WOOD PUTTY

WOOD SCREWS FINISH NAILS

Hammer

+

Nail Setter

Questions?

Standard Tasting Table

Assembly GUIDE

1. Find an open, flat area in which to work. Carefully remove all components from the box and remove banding
with a utility knife. Check the parts list to verify package contents.

2.

Arrange the end ladders on the floor so that the bottle support pieces face one another. Align the large gaps on each
end ladder. The end with the larger gap is the top of your rack. Attach a standard 8 column connector to the top
and bottom of your rack using the screws provided. Make sure the connectors are flush with the top and bottom
of your rack. (figure 1)

* Minimize the risk of splitting your ladders by drilling a 1/16" pilot hole before driving the wood screws.
For best results, drive the screw most of the way in with your drill, then finish tightening by hand.

BEGIN WITH BACK

1

OF RACK

Page 2

888.373.6057

or visit

wineracksamerica.com

Top of rack

3. Insert the middle ladders and finish securing the top & bottom connectors using the screws provided. (figure 2)

FINISH SECURING BACK

2

CONNECTORS