WineEnthusiast.com
800.356.8466
SWEDISH WINE RACK
A SSEMBLY INSTRUCTIONS
SWEDISH WINE RACK
EASY ASSEMBLY
4. Starting from the
bottom up (Figure
4a), tighten the
grommets (
B)
(Figure 4b) with a
Phillips screw driver.
Re-tighten after
one week. If extra
stability is required,
use appropriate
hardware to fasten
the unit to a wall.
5. If attaching
multiple units
together, insert
steel support rods
in corresponding
outer holes and
repeat
Step 2.
Figure 4a
Figure 4b
B
B
B
B
B
B
B
B
Call 800.356.8466 or visit our website at WineEnthusiast.com
Wine Enthusiast Companies, 333 North Bedford Road, Mount Kisco, NY 10549
W
ine Enthusiast and logo ar
e r
egistered trademarks of Wine Enthusiast Companies. @2009 Wine Enthusiast Companies
Made in Indonesia exclusively for WIne Enthusiast
®
.
14Tr Swedish Rack.qxp 5/19/09 3:03 PM Page 1
E
E
Shelf
Steel shelf support
Shelf slot
Figure 2b
SWEDISH WINE RACK
PARTS INVENTORY
SWEDISH WINE RACK
EASY ASSEMBLY
A.
4 Uprights
B.
56 Grommets
1. Starting with
the bottom
shelves (F), insert
steel shelf
supports (E)
through inner
holes in uprights
(A) with smooth
side facing
outward. Using a
Phillips screw
driver
, loosely
attach a grommet
(B) to each end
of the suppor
t
rod. (Figure 1)
A
E
B
B
B
E
Figure 1
B
EAS Y ASSEMBLY
C.
4 Back Support
Screws
E.
28 Steel
Shelf Supports
D.
Back Support
F.
14 Shelves
B
A
E
F
C
D
Figure 2a
3. Using a Phillips
screw driver, fasten
the back support
(D) with the four
provided screws (C),
to the rear uprights.
Screw holes
are located just
below the 2nd
gr
ommet down and
the bottom two
screw holes
between the 7th
and 8th gr
ommet
down (Figure 3).
Figur
e 3
2. Place bottom shelf
(F) onto the steel
support rods (Figure
2b)—sliding the rod
securely into the
shelf’s designated
slot (Figure 2a).
Tighten grommets
after placing bottom
shelf to securely hold
the structure together
for placement of the
other shelves.
Repeat
Step 2 with
the other 13 shelves.
Tighten grommets
after remaining
shelves
are in place.
F
A
C
C
D
C
C
14Tr Swedish Rack.qxp 5/19/09 3:03 PM Page 3
Loading...