Wine Corner JG32, JG45, CEXP45, BC45 Instruction Manual

I N S T R U C T I O N S

D E F Y I N G

C O N V E N T I O N

JG32 - JG45 - CEXP45 - BC45

Please read the instructions carefully and always keep them within reach

Please read the instructions carefully and always keep them within reach Please read the instructions carefully and always keep them within reach

Please read the instructions carefully and always keep them within reach
for easy consultation.

for easy consultation. for easy consultation.

for easy consultation.

All the instructions must be complied with
to correctly operate the equipment .

The manufacturer does not shoulder any responsibility
for failures due to noncompliance with the instructions
provided.

Does not accept claims on the values of temperature or humidity reached
related to detection tools inadequate or unsuitable or perceived sensori­ally, the reference values are those that appear on the display of the prod­uct detected with probes certified and calibrated by the manufacturer.

All packaging materials are environmentally friendly and may be re­cycled; please dispose of the package in an environmentally sound way.
Dismissed equipment is not valueless waste:

An environmentally sound disposal may recover precious materials

.

WARNING!

If on the appliance there’s this danger signal
generally on the compressor label
It mean that contain COOLING GAS R 600 a
Highly flammable

To avoid possibility of dangerous, please open the door 5 minutes
Before plugging the devic into a power outlet

I N D E X

PERFORMANCE AND CHARACTERISTICS OF THE EQUIPMENT PAG. 2

CHECKING THE EQUIPMENT UPON DELIVERY PAG. 2

CLEANING AND POSITIONING ACCESSORIES PAG. 2

CONNECTING AND INSTALLING THE EQUIPMENT PAG. 3

INSTALLATION AND SAFETY MEASURES PAG. 3

ADJUSTING TEMPERATURES PAG. 3

SINGLE-TEMPERATURE CELLARS PAG. 4

DUAL-TEMPERATURE CELLARS PAG. 5

ADJUSTING COMBIWINE TEMPERATURES PAG. 6

DOORS REVERSIBILITY PAG. 7

LIGHT SWITCH PAG. 7

SWITCHING ON AND OFF THE EQUIPMENT PAG. 7

AUTOMATIC DEFROSTING PAG. 7

HUMIDITY MAINTENANCE SYSTEM PAG. 7

SAFETY LOCK PAG. 7

SERVICING PAG. 8

GENERAL SAFETY NORMS PAG. 8

LAMP REPLACEMENT PAG. 8

MAINTENANCE AND CLEANING PAG. 9

APPLIANCE DESTRUCTION PAG. 9

WARRANTY PAG. 9

BUILT-IN DIMENSION PAG.10

MANUFACTURER EEC DECLARATION OF CONFORMITY

Hereby declares that the products are in compliance with the following directive:
2006/95/CE , 2004/108/CE, 2005/32/CE
With reference to harmonised standards:
EN60335-2-24:2010. EN60335-1:2002+A11+A1+A12+A2+A13+A14. EN62233:2008
EN55014-1:2006+A1:2009. EN55014-2:1997+A1+A1:2001+A2:2008.
EN61000-3-2:2006+A1:2009+A2:2009

1

PERFORMANCE AND CHARACTERISTICS OF THE EQUIPMENT

CONDITIONING CELLARS TO STORE AND SERVE WINE

GENERAL OPERATING INSTRUCTIONS OF SINGLE-

TEMPERATURE AND DUAL TEMPERATURE CELLARS

This appliance is certified for domestic use.
This equipment was conceived to replicate the ideal condition of a good natural cellar. To replicate such a peculiar
climate, IP uses a double "hot/cold" automatic circuit capable of ensuring the desired temperature inside the cellar.
An external temperature ranging between 0° C and + 32°C does not affect the stable internal temperature. Ideal hu­midity, stable temperature, anti-UV ray’s glass and the use of special compressors on rubber supports ensure lack
of vibrations, low noise levels and low energy consumption.

CHECKING THE EQUIPMENT UPON DELIVERY

We suggest to unpack the equipment immediately after the parcel is delivered to check that it is whole and no
damage was caused during transport.
Any damage must be immediately reported to the carrier even if it was not identified until installation.
Damaged equipment may never be returned to the manufacturer without prior notice and unless prior written
authorisation has been received.

CLEANING AND POSITIONING ACCESSORIES

Before start-up wash inside the cellar and the accessories with neutral soap to remove the typical smell of new
products.
Place internal accessories in the most suitable way for use.

Moving shelves: to remove the shelves lift the right part at the groove on the side, than pull forward to remove. Do on
reverse to install the shelves. See the following picture.

Note: Maximum capacity for each shelf Kg 15

2

1

2

A