Windster Hoods WS62N30 User Manual

www.windsterhood.com

User’s Manual

WS-62N30SS WS-62N36SS

Please read this operation manual thoroughly before using your range hood. Store it in a safe location for when you need to reference it in the future.

NOTE: PLEASE INSPECT HOOD

IMMEDIATELY UPON RECEIVING.

WALL MOUNT SERIES

CLAIM OF DAMAGE AFTER 7 DAYS OF DELIVERY WILL BE DENIED.

This unit is designed for indoor

residential use only. DO NOT USE OVER A WOOD GRILL OR MOUNT IN OUTDOOR ENVIRONMENT.

TABLE OF CONTENTS

Table of Contents

Safety Information .............................................................. 2 – 3

Content Checklist ..................................................................... 4

Measurements ........................................................................... 5

Preparation ................................................................................ 6

Installation ........................................................................... 7 – 8

Installation Diagram ................................................................... 9

Operation & Features ............................................................. 10

Cleaning & Maintenance ......................................................... 11

Troubleshooting ...................................................................... 12

Part List / Replacement / Wiring Diagram ............................. 13

Warranty / Contact Us ..................................................... 14 – 15

SAFETY INFORMATION

TO REDUCE THE RISK OF A FIRE, ELECTRICAL SHOCK,

AND/OR INJURY OBSERVE THE FOLLOWING:

 Unit is intended for indoor residential use only. If you should have questions,

contact the manufacturer at the address or telephone number listed in the warranty.

 In case the unit should need to be cleaned or repaired, switch power off at

service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

 Installation work and electrical wiring must be done by a qualified technician in

accordance with all applicable codes and standards, including fire-rated construction.

 Sufficient air is needed for proper combustion and exhausting of gases

through the flue (chimney) of fuel burning equipment to prevent back drafting.

Follow the heating equipment manufacturer’s guideline and safety standards

such as those published by the National Fire Protection Association (NFPA), and the American Society of Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

 Because the unit is made of stainless steel, it may contain sharp edges. Be

careful to avoid cuts and abrasions by wearing protective gloves during installation and cleaning.

 Before you begin to cut or drill into the wall, verify that there is no electrical

wiring or any other hidden electrical components.

 Ducted fans must always be vented to the outdoors.  The unit must be properly grounded and installed at the recommended height

before beginning operation.

 To reduce the risk of fire, use only metal ductwork.

CAUTION: FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS

SAFETY INFORMATION

TO REDUCE THE RISK OF FIRE, OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE.

 Regardless of heat level, never leave any surface materials unattended while

operating an open flame.

 Always turn hood ON when cooking at high heat or when flambéing food (i.e.

Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé).

 Depending on amount of usage, clean ventilating fans and filters frequently.

Grease should not be allowed to accumulate on fan or filter. For instructions on the how to clean, see maintenance page.

 Never leave surface units unattended at high settings. Boil-overs may cause

smoking and greasy spillovers may ignite as result. Heat oils slowly on low or medium settings.

 Use proper pan size. Always use cookware appropriate for the size of the

surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:

 SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then

turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL 911.

 NEVER PICK UP A FLAMING PAN —Doing so may result in serious burns

and possibly spread the fire.

 DO NOT USE WATER – Grease fire must be extinguished before further

action may be taken. Using water will agitate the grease and may cause a violent steam explosion.

 Use a Fire Extinguisher ONLY if:

 You know you have a Class ABC extinguisher, and you already know

how to operate it.

 The fire is small and contained in the area where it started.  The fire department is being called.  You are able to safely control the fire with your back to an open exit. *

Based on ―Kitchen Fire safety Tips‖ published by NFPA.

CONTENT CHECKLIST

1. CONTENTS INCLUDED

a. (1) WS-62N series (30‖ or 36‖) hood assembly b. (1) Lower duct cover (16-5/8‖) c. (1) Upper duct cover (19-3/4‖) d. (1) User’s manual e. (1) 7‖ Damper transition adapter collar f. (1) Aluminum filter g. (1) Screw packet

2. CONTENTS NOT INCLUDED

a. WS-62NEXT (Extension duct cover) b. WS62-NBF (Baffle filter) c. WS-62NDK (Ductless kit) d. WS62-NCF (Charcoal filter) e. WS-62NCFMR (CFM reducer) f. 6‖ / 7‖ Aluminum or metal piping

3. TOOLS REQUIRED (NOT INCLUDED)

a. Safety gloves b. Safety glasses c. Electric drill w/ starter bit d. Utility knife e. Spirit level f. Measuring tape g. Writing instrument (pen, marker, pencil) h. Aluminum tape

+ 11 hidden pages