Windsor Design 61488 Owner's Manual & Safety Instructions
Page 2 For technical questions, please call 1-800-444-3353. Item 61488
Table of Contents
Safety ......................................................... 2
Specifications ............................................. 3
Setup .......................................................... 3
Parts List and Diagram ............................... 6
Warranty ..................................................... 8
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
IMPORTANT SAFETY INFORMATION
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in serious injury.
Save all warnings and instructions for future reference.
1. Do not exceed weight capacities for the
Workbench shelves and drawers. Be aware of
dynamic loading! Sudden load movement may
briefly create excess load causing product failure.
2. Use only on flat, level and hard surface capable of
supporting the Workbench and any item(s) placed on
Workbench. Evenly distribute load to avoid tipping.
3. Use as intended only. Do not use Workbench to
perform task for which it was not designed.
4. For indoor use only.
5. Assemble only according to these instructions.
Improper assembly can create hazards.
6. Wear ANSI-approved safety
goggles during assembly.
7. Keep assembly area clean and well lit.
8. Keep bystanders out of the area during assembly.
9. Do not assemble when tired or when under
the influence of drugs or medication.
10. This product is not a toy. Do not allow children
to play with, on or near Workbench.
11. Inspect before every use; do not use
if parts are loose or damaged.
12. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
SAVE THESE INSTRUCTIONS.
SAFETY OPERATION MAINTENANCESETUP
Page 3For technical questions, please call 1-800-444-3353.Item 61488
Specifications
Maximum Weight Capacity
550 lb evenly distributed as follows:
Bench Top - 250 lb
Bottom Shelf - 200 lb
Each Drawer - 25 lb
Vise Capacity 7"
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding
the parts listed in the following pages, refer to
Parts List and Diagram on page 6.
Note: Finger tighten all connections until
assembly is done. Assemble the Workbench
on a flat, level, hard surface.
1. Insert Connecting Nuts (16) into Cross Braces (4) so
that the slots are horizontal and their holes line up
with the holes on the Cross Braces.
4
16
Slot
Figure A
2. Construct the Shelf Assembly by sliding the
Shelf into the grooves on the Cross Braces.
4
4
3
Figure B
3. Turn the Legs (6) upside down and attach the
Shelf Assembly to the Legs using Bolts (15).
15
15
15
15
6
6
Figure C
4. Lay the Table Top (1) upside down on
a flat, non-abrasive surface.
5. Attach the Drawer Support (7) using Screws (17).
7
17
1
Figure D
SAFETYOPERATIONMAINTENANCE SETUP
Loading...