Winco US AP-12 Instruction Manual

AP-12

APPLE PEELER

www.wincous.com

APPLE PEELER

Introduction

To get the most out of your new apple
peeler, please read through these
instructions before use. We also recommend
that you save the instructions in case you
need to refer to them at a later date.

Special Safety Instructions

Be aware that the blade and prongs are
sharp.

The apple peeler must not be washed in the
dishwasher.

Rinse the apple peeler in hot water with a
little dishwashing liquid before use.

Main Components

1. Handle for suction cup

2. Axle

3. Handle

4. Locking arm

5. Base (with suction cup)

6. Holder for peeling blade

7. Wing nut

8. Blade for coring and spiral slicing

9. Prong

10. Adjustment screw for peeling blade

11. Peeling blade

12. Wing nut for peeling blade

Handle Assembly Before First Use

Press the locking arm (4) to release the axle
and pull the handle (3) and axle (2) fully out.

Unscrew the handle from the axle and turn
it the right way around. Screw it on again.

Instructions for Use

Place the base (5) on a at surface and
secure it using the suction cup by pushing
the handle (1) down.

Place an apple on the prongs (9) stalk end
rst and turn the handle to push the apple
toward the peeling blade.

The apple will be peeled by the blade, sliced
in a spiral and the core will be removed.

Remove the peeled apple.

Press the locking arm and pull the handle
and axle out. Remove the core from the
prongs.

Wash the apple peeler in hot water with a
little dishwashing liquid and dry it
thoroughly.

Main Components

You can center the blade for coring and
spiral slicing by loosening the wing nut (7)
slightly, releasing the locking arm (4) and
pushing the axle forward until the prongs
go through the ring blade to the core. Hold
the blade for coring and spiral slicing (8)
very rmly and tighten the wing nut again.

You can adjust the minimum apple
diameter by adjusting the adjustment screw
(10) using a straight slot screwdriver until
the required distance is achieved.

You can set the peel thickness by loosening
the wing nut (12), adjusting the peeling
blade (11) to the required peel thickness
and retightening the wing nut.

www.wincous.com