Side I/O ............................................................................................... 37
01750229640 C BEETLE /Express, BEETLE /Express 15 - Installation Guide
Manufacturer’s Certification
The device complies with the requirements of the EEC
directive 2004/108/EC with regard to “Electromagnetic compatibility” and 2006/95/EC “Low Voltage Directive”.
Tested Safety
In addition, the device has received the UL symbol and
cUL symbol.
The device complies with the requirements of the BSMI
(Bureau of Standards, Metrology and Inspection, Ministry of
Economic Affairs) directive CNS14348 with regard to
“Electromagnetic compatibility” with the limits for a Class B
product.
Manufacturer’s certification
FCC-Class A Declaration
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not in-stalled and used in
accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Le présent appareil numérique ne génère pas de bruits radioélectriques
dépassant les limites applicable aux appareils numériques de la “Class A”
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.
This installation guide provides you with the information you require to
install the BEETLE/ Express or BEETLE/ Express 15 system, collectively
known as the system.
Symbols used in this guide
- Text following this mark represents an item in a
“ “ Text in quotation marks contains references to
● Paragraphs following this symbol are actions to be
BEETLE/ Express carries a 10.4” Color TFT
display and BEETLE/ Express 15 carries a 15”
Color TFT display
list.
other chapters or sections in this document.
performed in the specific order.
Text following this symbol has to be given special
attention in order to avoid damage or injury.
This symbol identifies paragraphs which contain
general notes to facilitate use of the device and
help avoid operating errors.
Please read the following notes carefully before doing any work on
the device.
Installation notes
When installing the device and/or doing any work on it, make sure that it
is disconnected from the power.
General safety precautions
This device complies with the relevant safety regulations for information
processing equipment.
- Note the warning and information labels on the device.
- The device is equipped with a safety-tested power cable, which
must be connected only to a grounded outlet.
- Always hold the plug when removing the power cable. Never pull
the cable itself.
- Have damaged power cables replaced immediately.
- The lithium battery must be disposed of in accordance with local
regulations for special waste.
- If the display element is damaged and the liquid crystal solution
leaks out onto your hands or clothing, please wash your hands or
clothing immediately under running water for at least 15 minutes,
using soap or alcohol. If the liquid comes into contact with your
eyes, consult a medical doctor immediately.
- Make sure that there is always free access to sockets used or to the
electrical circuit-breakers of the house installation.
- In case of an emergency (e.g. damaged cabinets, control or power
cables, liquids or foreign objects in the device), switch off the device
immediately and inform the customer service responsible for you.
- During the thunderstorm, data transmission lines must not be
connected or disconnected.
- Only use accessories and extension components that have been
approved by us. Nonobservance can result in damage to the system
or violations of regulations concerning safety, radio interference and
ergonomical requirements.
- To clean the device only use cleaning agents approved by Wincor
Nixdorf International GmbH.
Repairs
Repair work may only be carried out by authorized personnel.
Unauthorized opening of the device or repair work carried out
improperly could result in considerable danger to the user.
In case of noncompliance, Wincor Nixdorf International GmbH
excludes all liability.
Environmental protection does not begin when the time has come to dis-pose
of the system; it begins with the manufacturer. This product was de-signed
according to our internal norm “Environmental conscious product design and
development”.
The system is manufactured without the use of CFC and CHC and is
produced mainly from reusable components and materials.
Please do not stick labels onto plastic case parts. This would help us to re-use
components and material.
But there are still some parts that are not reusable. Wincor Nixdorf International GmbH guarantees the environmentally safe disposal of these parts in
a Recycling Centre, which is certified pursuant to ISO 9001 and ISO 14001.
You can protect our environment by only switching on your equipment when it
is actually needed. If possible, even avoid the stand-by-mode as this wastes
energy, too. Also switch your equipment off when you take a longer break or
finish your work.
Please contact your competent branch or the Recycling Centre Paderborn (for
European countries) for information on how to return and reuse devices and
disposable materials under the following mail address.
Email: info@wincor-nixdorf.com or on the internet.