Winchance Solar MU-108 Owner's Manual
MU-108
Owners Manual
Solar Speaker Parts
REMOTE CONTROL
DOCKING STATION
SOLAR SPEAKER AC CABLE
Model No. : BI, BI20-120150-AdV for CE
BI, BI20-120150-AdU for FCC
Input: AC 100-240V～50/60Hz 0.5A
Output: DC 12V --- 1.5A
DOCKING STATION AC CABLE
Model No. : BI, BI07-050140-AdV for CE
BI, BI07-050140-AdU for FCC
Input: AC 100-240V～50/60Hz 0.5A
Output: DC 5V --- 1.4A
AUDIO CABLE
SOLAR SPEAKER
AUXILIARY CABLE
STEP 2
Charging the solar speaker with your AC/DC adaptor.
A
Charging your devices out of the box
POWER PORT
AUX IN
MP3/
DC12V
BOTTOM OF SOLAR SPEAKER
Plug the solar speaker AC adaptor into the wall, next plug the opposite end into the DC portal
on the bottom of the solar speaker. When AC adapter is plugged in, red LED on speaker
bottom lights up.
O
F
F
3
1
2
Charging the docking station with your AC/DC adaptor.
B
Channel
TOUCH 8,16,32GB10GB/20GB
NANO
30GB/60GB
MINI
DOCKING STATION ADAPTORS
STEP 1
For first time use, remove pull tab from between the battery and its connector.
(See remote control instructions for battery replacement)
REMOTE
CONTROL
PULL TAB
DC 5V
POWER PORT
OFF
1
3
2
BACK OF DOCKING STATION
Plug the docking station AC cable into the wall, next plug the opposite end into the DC portal
on the back of the docking station
. The iPod will only charge in the docking station pin when the
docking station is plugged into a AC outlet
For first time use allow both the speaker and the docking station to charge
*
for 4 full hours to ensure a complete charge
Charging The Solar Speaker Using The Sun.
C
.
Place the solar speaker in direct sunlight for 15 hours to
charge the batteries.
Solar panel may have protective film. THIS MUST BE REMOVED PRIOR TO USE.
O
F
F
1
2
3
Channel
MP3/
A
UX IN
DC12V
O
F
F
1
2
3
Channel
Depending on your iPod (nano, mini, 30GB, etc) select the correct docking station adaptor. ( See parts Included ) and snap in to place. Gently press your iPod down
onto the docking pin until flush. Set your iPod to an appropriate volume, and press play.
There might be a slight delay in sound from your speaker once play is pressed, continue to press the volume key on your remote to make sure the volume is at a audible level.
The iPod can be controlled using the keys on your remote or on the iPod itself. On a full charge the docking station and solar speaker can be expected to run approximately
3-10 hours (depending on volume setting) before recharging is required
DOCKING STATION ADAPTOR
To get started playing music you will need to first move the channel switch from the off position to one of the three available channels on both the solar speaker as well as your docking station.
Please note that both the speaker and the docking station must be on the same channel. You will know that both units are powered on by the indicator light, which is located on the front
of the speaker as well as the docking station.
ON/OFF/CHANNELS SWITCH
DC12V
OFF
1
2
3
OFF
1
2
3
BACK OF DOCKING STATION
ON/OFF/CHANNELS SWITCH
BOTTOM OF SOLAR SPEAKER
STEP 2 Contd.
page 2
BATTERY STATUS INDICATION SPEAKER:
• Green light indicates a battery capacity of 80%-100%.
• Yellow light indicates a battery capacity of 20%-80%
• Red light indicates a battery capacity of less than 20%
BATTERY STATUS INDICATION DOCKING STATION:
Red light indicates a battery capacity of less than 20%.
Yellow light indicates a battery capacity of 20%-80%.
Green light indicates a battery capacity of 80%-100%.
• Flashing red light indicates that the battery capacity exhausted. After one
hour speaker turns off automatically.
NOTE: The front LCD lights will change
color to show the charge progress.
• Flashing green light indicates that the speaker is in hibernation, battery
capacity is greater than 1%.
Blue lights on speaker will light up at night.
STEP 3
Powering Your New Solar Speaker And Docking Station
TROUBLESHOOTING
STEP 4
There is a 10 minute cutoff on the docking station with inactivity, so make sure you have power to your docking station by pressing the power button on your remote.
Deciding How To Listen To Your Music
A B C
iPod wireless connection through docking station
A
MP3 or home audio wireless connection through docking station auxiliary port and audio input port iPod/MP3 Direct solar speaker connection
TROUBLESHOOTING
(1) If no sound is heard, first reconnect the docking station and speaker to the wall outlets to charge for 4 hours.Also make sure your iPod is set at an appropriate
volume, as well as on your docking station using the volume key on your remote. (2) Ensure the docking station is within 150 feet of the solar speaker and has a clear line of sight.(3) If there
is interference when the docking station is playing, choose a different audible channel on both the docking station and solar speaker. (Note the same channel must be selected on both)
Loading...