Wilson Electronics 304452-50, 304451-50, 304471-75, 304472-75, 301135-50 Installation Manual

...
Wide-Band
Panel Antenna
Window, Ceiling, Wall
& Outdoor Mounts
Wilson
®
The wide-band panel antenna is vertically polarized. For optimum
performance, install the antenna with the cable running from the
bottom or the top.
WINDOW
PART# 304452-50 Ohms PART# 304472-75 Ohms
CEILING
PART# 304451-50 Ohms PART# 304471-75 Ohms
WALL
PART# 301135-50 Ohms
UPGRADE-PART# 301147-50 Ohms
PART#301155-75 Ohms
OUTDOOR
PART# 301157-50 Ohms
Appearance of device and accessories may vary.
Antenna
1
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.
Window Mount:
PART# 304452 PART# 304472
Ceiling Mount:
PART# 304451 PART# 304471
Wall Mount:
PART# 301135 UPGRADE-PART# 301147 PART#301155
Outdoor Mount:
PART# 301157-50 Ohms
Optional In-Wall Mount Accessory:
PART#301155
In-Wall Mounting
Bracket
(901123)
Wilson Signal Boosters Amplify Coverage
When used in conjunction with your antenna, a Wilson Electronics Signal Booster can improve your cell phone and laptop data card coverage area more than 20 times. Wilson Electronics manufactures a wide range of Wireless, Direct-Connect and Adjustable Gain Signal Boosters for mobile or in-building use. See your dealer for details or visit www.WilsonElectronics.com.
See your dealer for details or visit
Appearance of device and accessories may vary.
Wide-Band Panel Antenna Window, Ceiling, Wall & Outdoor Mounts
Window Mount Installation
Find the window that faces the direction of the nearest cell tower. The signal strength function on your cell phone can help you determine this. See the Technical Support section of Wilson
Electronics website,
www.WilsonElectronics.com,
for instructions on accessing the signal
strength function on your particular phone.
Choose an inside window location where the antenna will be hung. Clean the window and the suction cups with glass cleaner.
It is important that the small tabs on each suction cup be facing outward so they may be used to remove the antenna from the window if desired.
Use fi rm and even pressure to attach the antenna to the window without
breaking the glass. Avoid excessive or sudden pressure against the glass.
Refer to Signal Booster instructions for separation requirements.
To be used as your outside antenna which communicates with the cell tower
Wide-Band Panel Antenna
Window Cradle Mount
Attach to Window
Slide Panel Antenna into cradle
+ 3 hidden pages