Dual-Polarity Dome Antenna
Part# 301123
This package contains: Dual-Polarity Dome Antenna, antenna installation
kit, template with instructions for installing on the ceiling and for installing
on the wall. See reverse side for installation template.
TECHNICAL SUPPORT
Call Toll-Free 866-294-1660
E-mail tech@wilsonelectronics.com
Visit www.wilsonelectronics.com
Specifi cations
Part Number 301123
Frequency Range 800~900 MHz
Gain 5.2 dBi
Beamwidth Horizontal Plane 360°
Beamwidth Vertical Plane 150°
Polarization Horizontal and Vertical
Impedance 50 ohms
VSWR 1.5 : 1
Connector N-Female
Diameter 7.72 (inch) / 19.6 (cm)
Weight 0.69 lbs / 0.31 kg
Wilson
Electronics, Inc.
3301 East Deseret Drive, St. George, Utah 84790
For additional technical support visit
www.wilsonelectronics.com
Phone: 866-294-1660
®
Dual-Polarity Dome Antenna
Installation Instructions and Guide
The Dual-Polarity Dome Antenna can be installed
on the wall or ceiling.
screw
location
Find desired location for the dome antenna. Verify the
dome antenna and the outside antenna have necessary
separation (see amplifi er instructions for separation
requirements).
The dome antenna must be installed at least seven feet above
the fl oor.
Place the template where the dome antenna will be installed.
Attach the template with masking tape or other suitable adhesive
tape. NOTE: make sure holes that need to be drilled are NOT over
a ceiling or wall stud.
If you would like to run the cable into the ceiling or
wall, drill a one inch hole in the middle of the template
indicated by . The dome antenna has a notch on the
edge of the antenna (see the top of the template) where
cable can be run, so drilling a hole is not necessary.
Included are two (2) sets of installation screws; A) 3 bolts with
nuts and washers, B) 3 self-starting screws.
A) If using the included bolts, drill a 1/8” hole through each
of the three small circles marked “screw location”. Remove
template, attach the amplifier cable to the dome antenna, put
the bolts through the drilled holes and tighten down with
included nuts and washers. Be careful not to over tighten.
B) If using the self-starting screws, mark the screw
locations, remove the template and attach the amplifier
cable to the dome antenna. Place the dome antenna
flush against the wall or ceiling and screw in the
self-starting screws until snug. Be careful not to
over tighten.
Part # 301123
cable
notch
Ceiling Installation
AC/DC
Power Supply
Wall Installation
AC/DC
Power Supply
screw
location
For any questions or comments, please
contact technical support toll free at
866-294-1660 or
tech@wilsonelectronics.com
screw
location
Part # 104032 Dome - 12.18.07
Loading...