Wilson Electronics 301121 Installation Instructions And Template

Dual-Band Dome Antenna

Part# 301121

This package contains: Dual-Band Dome Antenna, antenna installation kit,
and a template with instructions for installing on the ceiling. See reverse
side for installation template.

TECHNICAL SUPPORT

Call Toll-Free 866-294-1660

E-mail [e-mail]

Visit www.wilsonelectronics.com

Specifi cations

Part Number 301121
Frequency Range 800~910 MHz / 1800~1990 MHz
Gain 2.5 dBi
Polarization Vertical
Max Power 50 watts
Impedance 50 ohms
Connector N-Female
Diameter 8 (inch) / 20.32 (cm)

Wilson

Electronics, Inc.

3301 East Deseret Drive, St. George, Utah 84790

For additional technical support visit

www.wilsonelectronics.com

Phone: [phone]

®

Part # 301121

Dual-Band Dome Antenna

Installation Instructions and Template

The Dual-Band Dome Antenna is designed for horizontal

installation on a ceiling. It is not designed for a vertical or

slanted surface, such as a wall.

screw

location

Select a location on the ceiling that you can access from above to run the

antenna cable. Verify that your chosen location allows for the necessary

separation between the dome antenna and the outside antenna (see

amplifi er installation instructions for antenna separation requirements).

Tape this template in the selected antenna location. NOTE: ensure that the

cable connector location (marked by ) is NOT below a ceiling stud. Drill
a 5/8-inch hole in the template at the spot marked . Feed the cable from
above through the hole.

Included are two sets of mounting hardware: A) 3 bolts with nuts and
washers, B) 3 self-starting screws, and 3 mounting plugs.

A) If using the bolts, drill a 1/8” hole through each of the small

circles marked “screw location.” Remove template from the

ceiling, attach the dome antenna to the amplifier cable, insert the

bolts through the drilled holes, and tighten against the ceiling with

the enclosed nuts and washers. Snap the plugs into place on the

mounting holes.

B) If using the self-starting screws, mark the screw locations, remove the

template, and attach the amplifier cable to the dome antenna. Place the

antenna flush against the ceiling and screw in the self-starting screws

until snug. Be careful not to over-tighten. Snap the plugs into place

on the mounting holes.

If you have any questions about the installation procedure,

please contact our Technical Support Department toll free at

866-294-1660 or email [e-mail].

Ceiling Installation

AC/DC

Power Supply

Dome Antenna

screw

location

Outside Antenna

Amplifi er

screw

location

Part # 104031 - 09.04.07