Wilson WAM-5520-500, WAM-5520-375-500, WAM-5500-375-500 User Manual

 WAM-5500-375/500
 WAM-5520-375/500

WILS-MATIC

AUTO TUBE PUNCHER

SM-165

OPERATING INSTRUCTIONS

&

SERVICE MANUAL

Rev: A, 2/22/2007

TO REDUCE THE RISK OF INJURY AND EQUIPMENT DAMAGE

USER MUST READ AND UNDERSTAND OPERATOR’S MANUAL.

Thomas C. Wilson, Inc.

21-11 44th Avenue, Long Island City, New York 11101

Tel: [phone] Fax: [phone] http://www.tcwilson.com

E-mail: [e-mail]

SAFETY INSTRUCTIONS

SM-165

WARNING!

READ AND UNDERSTAND ALL INSTRUCTIONS

Failure to follow all instructions listed below, may result in

!

accident, fire and/or personal injury.

SAVE THESE INSTRUCTIONS

1. KNOW YOUR POWER TOOL. Read this service manual carefully.

2. GROUNDING INSTRUCTIONS. This product is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The plug must be plugged
into an appropriate outlet that is properly installed and grounded in accordance
with all local codes and ordinances.

3. KEEP GUARDS IN PLACE and in working order.

4. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.

5. AVOID DANGEROUS ENVIRONMENT. Keep work areas well lit.

6. STORE IDLE TOOLS. When not in use, tools should be stored in dry, high or
locked-up place – out of reach of children.

7. DON’T FORCE TOOLS. It will do the job better and safer at the rate for which it
was designed.

8. USE RIGHT TOOLS. Don’t force small tool or attachment to do the job of a
heavy-duty tool.

9. WEAR PROPEL APPAREL. No loose clothing or jewelry to get caught in mov­ing parts. Rubber gloves and footwear are recommended when working outdoors.

10. USE SAFETY GLASSES with most tools. Also face or dust mask if cutting op­eration is dusty.

11. DON’T ABUSE CORD. Never carry tool by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil and sharp edges.

12. SECURE WORK. Use clamps or a vise to hold work. It’s safer than using your
hands to operate tool.

13. DON’T OVERREACH. Keep proper footing and balance at all times.

14. MAINTAIN TOOL WITH CARE. Keep tools sharp and clean for best and safest
performance. Follow instructions for lubricating and changing accessories.

15. DISCONNECT TOOLS: When not in use; before servicing; when changing ac­cessories such as blades, bits, cutters, etc.

16. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking that
keys and adjusting wrenches are removed from tool before turning it on.

17. AVOID ACCIDENTAL STARTING. Don’t carry plugged-in tool with finger or
switch.

18. Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.

19. Do not use unit with combustible fluids or where combustible fluids or fumes may
be present.

2

ASSEMBLY

1. Place the drive unit on its wheels and bumper.

2. Take the handle and slide in to the slots.

3. Insert the quick-release pins thru the handle as shown below.

SM-165

PIN

OPERATING POSITION

The WILS-MATIC tube cleaner at all times should be operated with the

covers in place. In addition, it should be operated only with the top side
(side with shaft exit) up, as illustrated below:

SHAFT EXIT

UP

3

OPERATION 1

SM-165

INDICATOR

SHAFT & CASING

INLET

POWER

FEEDER

GUN

CONNECTOR

SHAFT EXIT

GUIDE

HANDLE BAR

4

WATER INLET

SHAFT DRIVE

CONNECTOR