Wilson TP-302 User Manual

 MODEL TP-302

AIR DRIVEN TUBE CLEANER

SM-135

OPERATING INSTRUCTIONS

&

SERVICE MANUAL

Rev: A, 5/11/2007

TO REDUCE THE RISK OF INJURY AND EQUIPMENT DAMAGE

USER MUST READ AND UNDERSTAND OPERATOR’S MANUAL.

Thomas C. Wilson, Inc.

21-11 44th Avenue, Long Island City, New York 11101

Tel: [phone] Fax: [phone] http://www.tcwilson.com

E-mail: [e-mail]

SAFETY INSTRUCTIONS

SM-135

READ AND UNDERSTAND ALL INSTRUCTIONS

Failure to follow all instructions listed below, may result

!

in accident, fire and/or personal injury.

WARNING!

SAVE THESE INSTRUCTIONS

1. Do not allow corrosive gases or foreign material to enter the unit. Moisture, oil­based contaminants, or other liquids must be filtered out.

2. Eye protection is always required when running motor.

3. Hearing protection is recommended when in close proximity to all operating air
motors.

4. Dust mask, non-skid safety shoes, hard hat, gloves and other personal safety equip­ment must be used.

5. Stay alert, watch what you are doing, and use common sense when operating a
power tool.

6. Dress properly. Do not wear loose clothing or jewelry.

7. Keep your work area clean and well lit.

8. Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases, or dust.

9. Disconnect the tool from the air supply before installing, making any adjustment,
changing accessories, servicing or storing tool.

2

OPERATION

RECOMMENDED OPERATING AIR PRESSURE 90 PSI

SPINDLE
1-1/16 X 12 THREAD

DEAD
HANDLE

SM-135

ROLL THROTTLE
VALVE

SCAVENGER INLET
3/8 NPT

AIR INLET
1” NPT

PROPER PIPING FOR AIR TOOLS

3

PARTS LIST

SM-135

4

Caution: Disassembly or reassembly of the unit must be performed by qualified personne l.
It is advisable to return units to the factory or consult the factory for necessary repair.