Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Mounting Strap (A)
Wire Nut (D)
Mounting Screw (B)
Threaded Pipe (E)
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Outlet Box
House Grounding Wire
Wire Nut(D)
Fixture Wire
Fixture Grounding Wire
Mounting Strap(A)
Green Grounding Screw(C)
Mounting Screw(B)
Threaded Pipe (E)
Top Loop(I)
Canopy(H)
Green Grounding
Screw (C)
Hex Nut (F)
Hex Nut(F)
Washer(G)
Washer (G)
Collar (J)
Canopy (H)
Loop Lock (K)
Top Loop (I)
Chain (L)
Installation Steps
Turn off the power at fuse or circuit box
1. Tighten the metal frame onto the fixutre body, then install the remainder.
2. Attach the threaded pipe to the mounting strap, and then secure it
with a washer and a hex nut.
3. Attach the mounting strap to the outlet box by using two
mounting screws.
4.Secure the top loop to the threaded pipe.
5. Secure the tube onto the stem of the fixture, thread fixture wires
through threaded tube and end of loop first.
6. Connect the chain:
- Determine length of chain needed to achieve
desired fixture height. (To remove excess chain
section, use pliers to bend link open.)
- Weave the fixture wires and fixture grounding wire
through the chain, collar and canopy.
7. Connect one end of the chain to the loop using
a loop lock.
8. Connect the other end of the chain to top loop
by using the other loop lock .
9. Thread the fixture wire and fixture grounding wire through the
top loop, threaded pipe and mounting strap.
10. Pull out the source wires from the outlet box. Make wire
connections using wire nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture
to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture
to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the
green grounding screw, and then connect it to the house
grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
Fixture Body
Collar(J)
Loop Lock(K)
Chain(L)
Loop Lock(K)
Tube
Stem
Loop
Flathead Screw
Metal Frame
Bulb Type T10 Max. 60W
(not included)
Page 2
11. Attach the canopy to the mounting strap by inserting the top loop, and then secure it with the collar.
12. Install the bulbs (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Strap (A)
Washer (G)
B
Mounting Screw (B)
Canopy (H)
Green Grounding
Screw (C)
Top Loop (I)
Mounting Hardware
(1 SET)
Wire Nut (D)
Collar (J)
A
Threaded Pipe (E)
Loop Lock (K)
Hex Nut (F)
Chain (L)
A: 18"
B: 24"
Loading...