Williams Sound R35N User Manual

Page 1
SAFETY INFORMATION
Hearing Safety:
This product is designed to ampli­fy sounds to a high volume level which could potentially cause hearing damage if used improper­ly. To protect your hearing and the hearing of others:
2. Set the volume level at the min­imum setting that you need to hear.
3. Do not allow children or other unauthorized persons to have
access to this product.
Personal PA™R35 Receiver
Instructions For Use & Care
CAUTION!
BATTERY SAFETY & DISPOSAL
Do not attempt to recharge dis­posable batteries, which may explode, release dangerous chem­icals, cause burns, or other seri­ous harm to the user or product.
PACEMAKER SAFETY
1. Before using this product with a pacemaker or other medical device, consult your physician or the manufacturer of your pace­maker or other medical device.
2. If you have a pacemaker or other medical device, make sure that you are using this product in accordance with safety guidelines established by your physician or the pacemaker manufacturer.
CAUTION!
CAUTION!
FRM 452E ©2007 Williams Sound Corp.
Page 2
2
RECYCLING INSTRUCTIONS
Help Williams Sound protect the environment! Please take the time to dispose of your equipment properly.
Product Recycling:
Please do NOT dispose of your Williams Sound equipment in the house­hold trash. Please take the equipment to a electronics recycling center; OR, return the product to the factory for proper disposal.
Battery Recycling:
Please do NOT dispose of used batteries in the household trash. Please take the batteries to a retail or community collection point for recycling.
4/11/07
APPROVALS
This product meets approval standards established for:
RoHS
FCC
WEEE
Page 3
OPERATING INSTRUCTIONS
1. Install two (2) AA alkaline or NiMH rechargeable batteries. If you’re using rechargeable batteries, they must be charged before using.
2. Plug the earphone into the “EAR” jack on the top of the unit.
3. Turn the receiver on by rotating the volume control knob clockwise. The receiver’s ON indicator should illuminate green.
4. Adjust the volume for your comfort.
5. To turn the receiver off, rotate the volume control knob counter-clockwise until it clicks off. The receivers’ ON indicator should go dark.
Note: To maximize battery life, turn the receiver off when it’s not in use.
DISCLAIMER: FCC RULES LIMIT USE OF THIS EQUIPMENT TO AUDITORY ASSISTANCE.
EARPAD CLEANING
Do not immerse the earphone in water or other cleaning agent. Foam pads may be removed and washed with a mild laundry soap solution, rinsed thoroughly, and air-dried. Foam pads may also be replaced with new pads.
BATTERY INFORMATION
Alkaline batteries (BAT 001): 100 hours Rechargeable NiMH batteries (BAT 026): 50 hours per charge
Batteries from other suppliers may provide different operating life.
NOTE: The ON indicator will illuminate RED to indicate a low battery
3
Page 4
4
Williams Sound products are engineered, designed and manufactured under carefully controlled conditions to provide you with many years of reliable service. Williams Sound warrants the Personal PA
R35 Receiver against defects in materials and workmanship for FIVE (5) years. During the first five years from the purchase date, we will promptly repair or replace the Personal PA
R35 Receiver.
Earphones, headphones, batteries, cables, carry cases, and all other accessory prod­ucts carry a 90-day warranty. Chargers carry a one year warranty.
WILLIAMS SOUND HAS NO CON­TROL OVER THE CONDITIONS UNDER WHICH THIS PRODUCT IS USED. WILLIAMS SOUND, THERE­FORE, DISCLAIMS ALL WARRANTIES NOT SET FORTH ABOVE, BOTH EXPRESS AND IMPLIED, WITH RESPECT TO THE PERSONAL PA
R35 RECEIVER, INCLUDING BUT NOT LIMITED TO, ANY IMPLIED WAR­RANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PUR­POSE. WILLIAMS SOUND SHALL NOT BE LIABLE TO ANY PERSON OR ENTITY FOR ANY MEDICAL EXPENS­ES OR ANY DIRECT, INCIDENTAL OR
LIMITED WARRANTY
CONSEQUENTIAL DAMAGES CAUSED BY ANY USE, DEFECT, FAILURE OR MALFUNCTION OF THE PRODUCT, WHETHER A CLAIM FOR SUCH DAM­AGES IS BASED UPON WARRANTY, CONTRACT, TORT OR OTHERWISE. THE SOLE REMEDY FOR ANY DEFECT, FAILURE OR MALFUNCTION OF THE PRODUCT IS REPLACEMENT OF THE PRODUCT. NO PERSON HAS ANY AUTHORITY TO BIND WILLIAMS SOUND TO ANY REPRESENTATION OR WARRANTY WITH RESPECT TO THE PERSONAL PA
R35 RECEIVER. UNAU­THORIZED REPAIRS OR MODIFICA­TIONS WILL VOID THE WARRANTY.
The exclusions and limitations set out above are not intended to, and should not be con­strued so as to contravene mandatory provi­sions of applicable law. If any part or term of this Disclaimer of Warranty is held to be illegal, unenforceable or in conflict with applicable law by a court of competent juris­diction, the validity of the remaining por­tions of this Disclaimer of Warranty shall not be affected, and all rights and obligations shall be construed and enforced as if this Limited Warranty did not contain the partic­ular part or term held to be invalid.
Page 5
5
If you experience difficulty with your system, call Toll-Free for Customer Assistance:
1-800-843-3544 (U.S.A.) or +1 952 943 2252 (Outside the U.S.A.)
If it is necessary to return the system for service, your Customer Service Representative will give you a Return Authorization Number (RA) and shipping instructions.
Pack the system carefully and send it to:
Williams Sound Corp. Attn: Repair Dept. 10321 West 70th Street Eden Prairie, MN 55344
Page 6
INSTALLING AND REPLACING BATTERIES
1. Open the battery compartment by lifting the tab on the back of the receiver with a finger.
2. To remove depleted batteries, pull up on the fabric strip.
3. If Alkaline (non-rechargeable) batteries are being installed, slide the battery selection switch above the battery compartment to the “Alkaline” position. If installing NiMH (or rechargeable) batteries, slide the battery selection switch to the “NiMH” position.
4. Press the batteries into place over the fabric strip. Be sure to observe proper polarity (+/–). Damage due to improper battery installation may void the warranty on the product. Close the lid.
5. When the sound becomes weak or distorted, replace or recharge batteries.
BATTERY CHARGING
Rechargeable batteries must be charged overnight before first time use. Drop-in charger points are located on the bottom of the R35 unit. For charger availability, please contact Williams Sound at (800) 843-3544.
CHANNEL TUNING
First, set the transmitter to the desired channel. Remove the antenna and connect an audio source. Move the receiver 25 feet away from the transmitter for tuning. Open the battery compartment on the R35 by lifting the tab on the back of the receiver with a finger. Locate the metal tuning slug above the batteries next to the “Channel Tuning” label. Using a small screw driver or tuning wand, turn the tuning slug in a counter-clockwise direction about two turns. Then, slowly turn the tuning slug in the clockwise direction until the signal is heard. There may be two signal points heard. The one which is received first is a false response. Be sure to continue tuning slightly further to the correct point, which will be much louder. Tune back and forth to find the center of the point of best response to the program being heard.
FRM 452E ©2007 Williams Sound Corp.
Loading...