Page 1
POCKETALKER® Ultra
Personal Amplifier
quick setup Guide
How it works
The Pocketalker Ultra amplies sounds closest to the listener while reducing background noise.
Important: If you wear a pacemaker or similar medical device, ask your doctor or the maker
of your device if you can safely use the Pocketalker.
Getting started:
1. Turn the Pocketalker on by turning the volume control
counter clockwise. The RED indicator light on the
top will turn on.
PLUG-IN
MIC
PLUG-IN EARPHONE /
HEADPHONE OPTION
2. Turn the volume down before putting on the
headphones.
3. Once the headphones are in place, slowly
turn the volume up to a comfortable level.
Keep the volume at the lowest level needed
to hear.
4. If you hear feedback (a howl or squeal), turn
down the volume and move the microphone
away from the earphone (or headphones).
5. Adjust the tone according to your preference.
6. Hold the microphone as close to the speaker
as you can.
7. When sitting down, place the Pocketalker on a
table or other at surface for best sound.
NOTE: Pocketalker is not a toy–do not allow children to play with it.
POWER ON / OFF
INDICATOR (FLASHES RED
TO INDICATE LOW BATTERY)
TONE
CONTROL
BELT CLIP
MIC JACK
(3.5 mm)
+
–
+
VOLUME
CONTROL
–
EARPHONE
JACK
(3.5 mm mono)
A289
10300 Valley View Rd • Eden Prairie, MN 55344
800-328-6190 / 952-943-2252 • FAX: 952-943-2174
www.williamssound.com
©2012 Williams Sound • All Rights Reserved
FRM 708A
Loading...