Williams Sound CHG 1012 Users Manual
CHG 1012 / PRO
Digi-Wave™ 12-Bay Charger
For use with Williams AV Digi-Wave™ DLT 300, DLT 100 2.0, DLT 100, DLR 360, DLR 60 2.0 and DLR 60.
Manual andUser Guide
Multi-bay, drop-in style charger.
CHG 1012
CHG 1012 PRO
MAN 169F
CHG 1012 Digi-Wave™ 12-Bay Charger
Figure 1: CHG 1012 Digi-Wave™ 12-Bay Charger
DLT 300
DLT 100 2.0
DLT 100
INSERT DIGI-WAVE DEVICES
FACING FORWARD
DLR 360
DLR 60 2.0
DLR 60
CAUTION!
Place the units facing forward. Placing the
unit in the charger incorrectly can damage
the connectors on the device.
Instructions:
1. Plug the power supply into the AC wall outlet. Plug the power connector into the rear of the CHG 1012 unit.
2. Insert the DLT / DLR units facing forward into the charging slot as illustrated in Figure 1. The unit(s) must be placed in the
charger facing forward to mate with the connectors. Units placed in the charger incorrectly may be damaged.
3. A red LED indicator on the DLT / DLR will illuminate when charging has started. When the batteries are fully charged, a green
LED is illuminated, indicating the charger is in maintain mode.
You may charge up to 12 DLTs or DLRs per CHG 1012 charger. It will take approximately five hours to fully charge
the batteries of a DLT, and 12 hours to charge the batteries of a DLR**.
NOTE: Before charging a receiver (DLR), make sure the battery switch (located inside the battery compartment) is in the NiMH
position and NiMH batteries are installed.
Troubleshooting
If no LEDs light up:
1. Check that the power supply is plugged into the AC outlet.
2. Be sure the DLT / DLR unit is facing forward in the charger (see Figure 1).
3. If charging a DLR, make sure the battery switch is set to the “NiMH” position and that NiMH batteries are installed (not
Alkaline).
NOTE: New batteries have various charge conditions, therefore, some batteries may take less time to fully charge.
Charging batteries generates heat. The DLT/DLR, charger, and power supply will feel warm when charging. Do not charge
batteries in a closed enclosure, such as a carry case or brief case. To ensure full battery charging, turn o the DLT /DLR when
recharging the batteries.
Loading...