Williams Sound ANT 033 Manual And User Manual

Remote Antenna Kit

Model ANT 033

Manual and User Guide

MAN 144B © 2011 Williams Sound

2

Overview

The ANT 033 is a 50 Ohm remote antenna kit designed for 863-864
MHz operation. It is intended for use with Williams Sound FM transmitter,
T800.

Contents

1 - Rack Mount Bracket Assembly

1 - WCA 088 Coax Cable, 3’, TNC connector

2 - #10-32 Screws and Nylon Washers

1 - Manual

FIG. 1: ANT 033 Assembly

ANT 032 (included with T800)
Rubber Duckie
Antenna with Swivel
TNC Connector

WCA 088

3’ Coax Cable

To Transmitter’s

Remote Antenna Jack

Mounting

Bracket

Connector

#10-32
Mount Screws &
Washers for Rack
Installation

3

ANT 033 Assembly & Install Procedure

Step 1: Select a mounting location for the ANT 033 Remote Antenna Kit.

The ANT 033 can be mounted on an audio rack, wall, corner, or
behind a wooden beam. If possible, avoid placing the antenna
within four feet of steel beams. Metal studs, ductwork, and foil­backed insulation can absorb radio energy, reducing the range of the
system.

Step 2: If installing on wall or other surface, use mounting bracket as a

template to mark position of mounting holes. Use appropriate wall
anchors and screws as necessary (not included).

Step 3: Thread the ANT 032 rubber duckie (included with T800) on to the

connector of mounting bracket (see FIG. A). Turn the TNC connector
on the ANT 032 clockwise by hand until connection is tight.

Step 4: Thread one end of the WCA 088 3’ coax cable on to the back of the

assembled bracketantenna unit. Use  ngers only to tighten.

Step 5: Use provided #10-32 screws and washers to mount bracketantenna

assembly on to audio rack; alternatively, use wall anchors and
screws (not included) to mount bracket-antenna assembly on to
marked wall/surface area. Make sure bracket antenna assembly is
secure.

Step 6: Attach other end of WCA 088 3’ coax cable to the TNC Connector

“Antenna” jack on the Williams Sound T800 transmitter. Use  ngers
only to tighten. NOTE: Do not bend coax cable sharply at any point.
The ANT 032 rubber duckie antenna should be vertical for best
performance, and to comply with FCC rules.

WARRANTY

The ANT 033 Remote Antenna Kit is covered by a 90 day warranty. If you
experience difculty with your antenna, call toll-free for customer assistance:
1-800-843-3544 (U.S.A.) or 1-952-943-2252 (Outside the U.S.A.)

If it is necessary to return the system for service, your customer service
representative will give you a Return Authorization Number (RA) and shipping
instructions.

MAN 144B © 2011 Williams Sound

Recycling Instructions

Help Williams Sound protect the environment! Please take
the time to dispose of your equipment properly.

Product Recycling

Please do NOT dispose of your Williams Sound equipment
in the household trash. Please take the equipment to an
electronics recycling center or return the product to the
factory for proper disposal.