Williams Sound ANT 029 Installation Guide

Model ANT 029

Rack Mountable Remote Antenna

INSTALLATION INSTRUCTIONS

The ANT 029 is a 75 Ohm rack mountable remote antenna designed
for 72-76 MHz operation. It is intended for use with Williams AV FM
transmitters (FM T55, PPA T45, PPA T35, PPA T27, etc.).

ANT 029 Assembly & Installation Procedure

ANT 021
RUBBER DUCKIE
ANTENNA WITH SWIVEL
F-CONNECTOR

MOUNTING
BRACKET

CONNECTOR

1. Select a mounting location for the ANT 029 Remote Antenna. The ANT 029 can be mounted on an audio rack, wall, corner, or
behind a wooden beam. If possible, avoid placing the antenna within four feet of steel beams. Metal studs, ductwork, and foil­backed insulation can absorb radio energy, reducing the range of the system.

2. If installing on wall or other surface, use mounting bracket as a template to mark position of mounting holes. Use appropriate
wall anchors and screws as necessary (not included).

3. Thread the ANT 021 rubber duckie on to the connector of mounting bracket (see figure 1). Turn the F-connector on the ANT 021
clockwise by hand until connection is tight.

4. Thread one end of the WCA 086 3’ coax cable on to the back of the assembled bracket-antenna unit. Use fingers only to
tighten.

5. Use provided #10-32 screws and washers to mount bracket-antenna assembly on to audio rack; alternatively, use wall anchors
and screws (not included) to mount bracket-antenna assembly on to marked wall/surface area. Make sure bracket-antenna
assembly is secure.

6. Attach other end of WCA 086 3’ coax cable to the F-Connector “Antenna” jack on the Williams AV 72-76 MHz transmitter. Use
fingers only to tighten.

NOTE: Do not bend coax cable sharply at any point. The ANT 021 rubber duckie antenna should be vertical for best performance,

and to comply with FCC rules.

(2) #10-32 MOUNT SCREWS & WASHERS
FOR RACK INSTALLATION

WCA 086
3’ COAX CABLE

TO TRANSMITTER
REMOTE
ANTENNA JACK

A170

MAN 139D

Warranty

The ANT 029 rack mountable remote antenna is covered by a 90 day warranty. If you experience diculty with your antenna, call
toll-free for customer assistance:

1-800-843-3544 (U.S.A.) or 1-952-943-2252 (Outside the U.S.A.)

If it is necessary to return the system for service, your customer service representative will give you a Return Authorization
Number (RA) and shipping instructions.

Recycling Instructions

Help Williams AV protect the environment! Please take the time to dispose of your equipment properly.

Product Recycling for Customers in the European Union:

Please do NOT dispose of your equipment in the household trash. Please take the equipment to a electronics recycling
center.

ANT 029

[e-mail] / www.williamsav.com

800-843-3544 / INTL: [phone]

© 2019, Williams AV, LLC

MAN 139D