Page 1
Installation Instructions for
990W8_3170_-POH
Pohl Outdoor Wall
WALL
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for wet locations.
Incandescent version may be dimmed with a standard incandescent
dimmer. version may be dimmed with a dimmer. ConsultLED LED
lamp manufacturer for additional information.
This instruction shows a typical installation.
8531701, 8631702, 8731701, 8831702
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
1.0
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2020 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
SAVE THESE INSTRUCTIONS!
Page 2
Install the Fixture
1A
JUNCTION BOX
3
MOUNTING PLATE
8
5
COVER
LAMP
FIXTURE
SCREW
6
7
1
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
2
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
3
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
4
Neatly place all the wires into the junction box, place the fixture base onto the mounting studs, and secure it in place using the fixture
5
screws.
6
Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
7
For Wet Locations, caulk around the base of the fixture with waterproof construction sealant.
For Models 8631702 and 8831702 Only: Install the cover to the top of the fixture.
8
2
Loading...