Page 1
Installation Instructions for
CO1101
Freeport Outdoor Wall
Outdoor
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for wet locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
CO1101, CO1111, CO1121, CO1131, CO1223
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2020 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
1.0
SAVETHESE INSTRUCTIONS!
Page 2
Install the Fixture
1A
ANCHOR
SOCKET
7
ANCHOR
SCREW
12
JUNCTION BOX
9
10
3 4
MOUNTING
PLATE
11
FIXTURE
SCREW
LAMP
6
GLASS
1
For Models CO1131 & COL1223 Only: Temporarily install the mounting plate to the junction box.
2
For Models CO1131 & COL1223 Only: Mark the anchor locations through the holes on the mounting plate. Remove the
mounting plate.
For Models CO1131 & COL1223 Only: Drill appropriate sized holes at the marked locations and install the anchors.
3
For Models CO1131 & COL1223 Only: Secure the mounting plate to the junction box and screw the anchor screws into the
4
anchors. Skip to step 6.
Secure the mounting plate to the junction box.
5
6
Install the glass by carefully inserting them into the fixture frame and bending the tabs to secure in place.
7
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage Information.
8
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
9
Connect the white fixture wire to the neutral power line wire with a wire nut.
10
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the junction box/fixture base, mount the fixture onto the mounting plate,
11
and secure it in place using the fixture screws.
12
For Wet Locations: Caulk around the fixture base with waterproof construction sealant.
1
Loading...