Wiley X SG-1 User Manual

GASKET INSTALLATION - STEP 1

As pictured, engage slot at the bottom of the lens gasket

1)
into the tab at the bottom of the hybrid frame.

GASKET INSTALLATION - STEP 2

Rotate the gasket up to engage the corresponding slot and

2)
tab at the top of the hybrid.

MAINTENANCE:

resistance. Please follow below instructions to prolong the life of your lenses
and keep them performing at their best:

Clean lenses with water only.
Do not use solvents or special cleaners.
Use micro-fiber cleaning cloth provided to gently wipe clean.
Never use paper products to clean and avoid wiping lens surface when dry

and/or dirty as this may potentially scratch the lens.

WARNING:

eyewear is not unbreakable and does not provide unlimited eye protection under all
circumstances and conditions. Misused, abused, scratched and/or damaged
eyewear can reduce impact protection (and void your limited warranty). Dirty
and/or wet eyewear can impair vision and reduce safety (resulting in personal injury
and/or property damage). Keep your Wiley X eyewear clean with water only. Do not
use solvents or abrasives as it could scratch or damage the product reducing its
effectiveness. Store your Wiley X eyewear in the protective case provided to
prolong the life of the lenses. Most of all, take all appropriate precautions when
wearing your Wiley X eyewear during hazardous and/or dangerous activities and
conditions. Wiley X, Inc. is not responsible for personal injury, property damage or
losses incurred while using Wiley X brand products.

Wiley X lenses are specially coated to offer superior abrasion

Wiley X brand eyewear is tested tough. However, impact resistant

7800 PATTERSON PASS ROAD, LIVERMORE CA 94550 USA

SØNDERGADE 8-10 7570 VEMB DENMARK

ERX-ICSG1(1)

SG-1

INSTRUCTIONS

COPYRIGHT © 2016 WILEY X, INC. ALL RIGHTS RESERVED.

WILEY X, WX, BLACK OPS, logos, tag lines and product names are trademarks or registered trademarks (marcas
registradas) of Wiley X, Inc. in the U.S. and other countries. Logos © 2007-2016 Wiley X, Inc. All rights reserved.

LENS REMOVAL

LENS REMOVAL

LENS REMOVAL

TEMPLE / STRAP REMOVAL

Hold the product as pictured. Lift the frame at the nose bridge while pushing down on

The lens to create about 1/4 inch seperaton between the lens
and frame.

Hold the frame at the nose piece and rotate the
lens from top of the frame.

Press the tab located in the graphic above to release
either the temples or strap.