PAGE 1 OF 3
(B1 & B2)
DROP LEAF TABLE
ASSEMBLY INSTRUCTIONS
PAGE 2 OF 3
(B1 & B2)
ASSEMBLY TIPS :
1. Remove hardware from plastic bag and sort by size.
2. Please check to see that all hardware and part are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning !
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishment.
ASSEMBLY INSTRUCTIONS
PARTS IDENTIFICATION:
B1 (BOX1)
AN
TABLE TOP
B2 (BOX2)
BN
CN
DN
EMPIRE COLUMN
EMPIRE LEG
MOUNTING BAR
HARDWARE IDENTIFICATION:
Z-B2 (BOX2) - HARDWARE PACK IS LOCATED IN (B2)
1
2
3
WRENCH
ALLEN WRENCH
BOLT
1PC
1PC
4PCS
2PCS
1PC
1PC
4PCS
4
5
9
10
SMALL LOCK WASHER
SMALL FLAT WASHER
HEX NUT
BIG LOCK WASHER
BIG FLAT WASHER
LEVELER
PAN HEAD SCREW
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY
PROCESS. HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
4PCS
4PCS
8PCS6
8PCS7
8PCS8
4PCS
8PCS
PAGE 3 OF 3
(B1 & B2)
ASSEMBLY INSTRUCTIONS
STEP 1
1.1 Align and fasten empire leg (CN) to empire column (BN)
using big flat washer (8), big lock washer (7) and hex nut (6)
and tighten with wrench (1).
1.2 Screw in leveler (9) to empire leg (CN).
CN
STEP 2
Align and fasten mounting bars (DN) to empire column (BN)
using bolt (3), small lock washer (4) and small flat washer (5)
and tighten with Allen wrench (2).
DN
BN
STEP 3
Place table top (AN) upside down on a soft surface. Align
and position mounting bar (DN) onto the marking at the
bottom of table top (AN). Then fasten using pan head
screw (10) and tighten with Phillips head screw
driver (Not Included).
STEP 4
Flip table over using two people to lift and flip this table.
Adjust leveler to touch the floor.
AN
Loading...