Wildix W-AIR70, W-AIR100, W-AIR150 User Manual

User Manual

Version updated: July 2016

The manual provides you with the necessary information about your W-AIR 70 / W-AIR 100 / W-AIR 150
cordless phones. Please read this guide to ensure the proper installation and operation of the phone.

Before using the handset

Unboxing
Using the battery
Using the Charger

Open Back Cover
Phone Overview
Main Menu
Login
Menu Operations

Local contacts

Shared PBX phonebooks

Call list

Register a handset
Call Control

Incoming call

Place a call

End a call

Hold

Call Transfer

Conference call
Settings

General Settings

Audio Settings

Alarm clock setting (W-AIR 100 / W-AIR 150)

Emergency alarms setting (W-AIR 150)

W-AIR 70 / W-AIR 100 / W-AIR 150 - User Manual / 1

Before using the handset

Unboxing

Examine the package for evidence of physical damage prior to opening. If there is a proof of
mishandling, report it to your certified Wildix Partner.

Make sure that all the components are present in the shipping package/box:

W-AIR 70:

- 1 x Handset Unit

- 1 x Charger with A/C adapter

- 2 x Battery, AAA

- 1 x Battery cover

- Optional belt clip case on demand, code: WAIR70-PC

W-AIR 100:

- 1 x Handset Unit with li-lion battery

- 1 x A/C Adapter

- 1 x Charger

- 1 x Belt Clip

- Optional case on demand, code: WAIR100-PC

W-AIR 150:

- 1 x Handset Unit

- 1 x A/C adapter

- 1 x Charger

- 1 x Battery

- 1 x Belt Clip Cover

- 1 x Pull Cord Cover

- 1 x Belt Clip

- 1 x Svirvel for belt clip

- 2 x Mounting screws

Compatible headsets:

- Wildix headsets: http://www.wildix.com/voip-phones-and-headset/#headsets

- Third party headsets integrated with Wildix https://manuals.wildix.com/headsets/

Using the battery

- Never dispose of the battery in fire, otherwise it could explode

- Never replace the battery in potentially explosive environments, for example close to

inflammable liquids/gases

- Use ONLY approved batteries and chargers from the vendor or the operator

- Do not disassemble, open or damage the battery, use it carefully to avoid a short circuit

Using the Charger

Input Voltage: 110-240VAC; Output Voltage 5.5VDC / 600mA.
For the best performance, charge the handset for at least 10 hours the first time.

When charging, make sure that the room temperature is between 0°C and 25°C / 32°F and 77°F.
Do not leave the handset in direct sunlight when charging. The battery has a built-in heat sensor that
stops the charging when the temperature is too high.
There is a charging status indicator on the phone display.

W-AIR 70 / W-AIR 100 / W-AIR 150 - User Manual / 2

Open Back Cover

W-AIR 70

W-AIR 100

W-AIR 150

The serial number and IPUI number of each handset is situated either on a label behind the battery, or
on the package label.

Phone Overview

W-AIR 70

Front view

1- Ear Speaker
2- Screen
3- Navigation Keys (Up/Down/Right/left)

Press Up and Down Navigation keys during a call to adjust the volume
Press Left Navigation key during a call to mute/unmute the microphone.

4- Selection Key (centre of Navigation key)
5- Off-hook key

Press during a call to activate the speaker mode.

6- On-hook key (End, ON/OFF Key, Back Key)
7- Left and Right Soft keys
8- Numeric Keypad

Rear View

9- Headset connector (3.5mm)
10- Used when speaker mode is enabled during a call
11- Battery back cover
12- LED indicator

W-AIR 70 / W-AIR 100 / W-AIR 150 - User Manual / 3