Wildix W01 FXS, W02 FXS, W04 FXS Quick Installation Manual

4/20/2017

W01/02/04FXS – Quick Installation Guide

The steps below help you to connect and configure the W01FXS, W02FXS and W04FXS media gateways. FXS
gateway allows you to connect analog phones and fax machines to your IP PBX.

Updated: March 2017

Quick Overview
Connection to power supply (old models without PoE)
Connection to Ethernet
Connection to the line
Provisioning of the gateway
Assign analog ports
Reset of the gateway

Quick Overview

Rear panel

Reset button

Power supply jack

Input: AC100V~240V, 50/60Hz

Output: DC 12V, 1.5A (W04FXS) or 1A (W01FXS)

Network ports

2 Ethernet ports RJ-45, 10/100 base-T

1 WAN port

1 LAN port configured in Bridge

FXS ports

1, 2 or 4 FXS ports (depending on the model), to connect to analog phone

Front panel

1 Power LED indicates that the gateway is powered

1 Status LED indicates that the system is startup successfully

1 Proxy LED indicates that the gateway is registered on SIP proxy (W04FXS only)

1 LAN LED indicates that the gateway is connected to the network via this port

1 WAN LED indicates that the gateway is connected to the network via this port

Phone LED (1 for W01FXS and 4 for W04FXS) indicate that analog phones are connected:

flashing LED indicates an incoming call

LED is ON indicates that the connected phone’s handset is lifted or the phone is engaged in a

1/4

conversation

Connection to power supply (old models without PoE)

Connect the FXS gateway using the power supply and the cable provided with the gateway, as it is shown on the
picture.

Connection to Ethernet

The gateway has one LAN port configured in Bridge mode and one WAN port set up as a DHCP Client. Connect one
of two ports to the same network as the PBX or an external DHCP server (for instance, its router) as shown on the
picture.

As soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the gateway
configuration.

In case the PBX is used as a DHCP server, the gateway is detected on the network automatically

In case an external DHCP server is used, check the list of the active leases to detect the IP address assigned
to the gateway

Connection to the line

FXS gateways have 1 or 4 ports (depending on the model) on the rear panel, marked as Phone1-Phone4. Connect
the ports to the analog phones.

2/4