Wildgame Innovations LO8C User Manual

Infrared Digital Scouting Camera

User’s Manual

Model # W4E

Includes

USB Cable 2 - Bungee Cords

Camera UnitFlextime Player

Software

NOTE: Flextime Player Software is optional.
Flextime files can be played by using most
media players.

page 1

User Manual

Features

RESOLUTION

FLASH

FLASH RANGE

SENSOR

SENSOR RANGE

IMAGE FORMAT

MEMORY

USB

IMAGE RESOLUTION

POWER SUPPLY

AUXILIARY POWER

BATTERY LIFE

ONBOARD POWER

HOUSING

MOUNTING

REDUX

MAX: 4 MP
24 High Intensity Infrared LED’s
up to 60 feet
Passive Infrared Sensor (PIR) Motion and Heat
up to 60 feet
JPEG - Digital Still / AVI - Digital Video
up to 64GB SD Card (not included)
5-PIN Mini USB style - included
High (4MP)

Medium (2MP)
Low (1.3MP)

8 AA-Cell batteries (not included)
External power port
Estimated up to 3 months (in PIR mode)

Battery life may be reduced in Flextime mode
(depending on Flextime setting)

Built in battery to retain Time and Settings
Weather resistant with rubber gaskets
2 Bungee cords - included
Technology to reduce motion blur during

transition time

page 2

Installing Batteries

Open

Open the door at the bottom of the camera by
unlatching the locking tabs.

1.

With the camera facing open, open the battery
compartment cover by sliding the latch to the

2.

left.

(Illustration A and B)

Illustration A

page 3

Illustration B

With the bottom of the camera
towards you, Make sure to insert the

3.

batteries into the camera with the
positive ends towards you where
marked positive and the negative ends
towards you where marked negative.

Close battery compartment cover. To
latch the cover simply pull the latch

4.

slightly to the left as you close the
battery compartment cover.

Load SD memory card (up to 64GB not

included) into the SD card slot with the

5.

connectors facing down.

TIPS:
Make sure the SD Card is unlocked (small
switch on the side of the SD Card) or the
camera LCD will read “LOCK”.

page 4

Power On

Test Mode

To turn the unit ON press and release
the power button.

1.

Check the battery level icon to ensure
the batteries just installed contain the

2.

proper charge level. If so, you are ok to
proceed with camera use.

Time/Date
Location

PIR Mode

Trigger
Flextime
PIR Mode
PIR Active
PIR Sense
Picture
Resolution
Delay

Flextime Both
P1 P2
Still Video
24Hr Day Night
Hi Med Lo
Regular Wide
Hi Med Lo
15s 30s 1m 2m 5m 10m

Interval

NOTE: LCD cycle through camera
information. PIR picture number >
Flextime number > Remaining
pictures > Time

LCD Ready Mode: The camera will
automatically enter Ready Mode if a

1.

button is not pressed for greater than
30 seconds. The status lights will
illuminate for a total of 2 minutes.

PIR LED Status Light: During the first
2 minutes of Ready Mode, the red light

2.

will illuminate when a PIR event is
triggered. The green light will blink
for 2-3 seconds when photo is taken
during this first 2 minutes. After 2
minutes all indicator lights will turn
off until a button is pressed.

page 5