Wilderness Systems PHASE 3 Installation Instructions

PHASE 3® AIRPRO SEAT BACK KIT

These instructions will guide you through the removal of the Phase 3 AirPro Backband and replacing it with the
Phase 3 AirPro Seat Back.

Kit Includes:

(1) Seat Back
(1) Seat Back Riser
(2) Retainer Bungees w/ hooks
(1) Riser Bungee
(1) Double Buckle Strap
(1) Spring and plunger for installation into boat

INSTALLATION INSTRUCTIONS:

1. Get seat back riser (front view): Pivot nub on bottom will be on right side.

2. Tie a single knot on one end of 25” -3/16 bungee and insert non-tied end through left hole on bottom of seat back riser.

3. Thread it through the backside and through the adjacent hole on the right side and tie a single knot on the
end. Two knots should now be visible in front creating a bungee loop on the backside of the riser.

Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 Rev. 06/17#59504276

4. Riser with looped bungee (front view)

5. From the backside of riser, insert one 1/4” bungee with hooks through top outer hole of the seat back riser.

6. Flip riser over. Tie a single knot on the front side of riser (Knot should fit inside the recess on the front of the riser).

7. Repeat step 6 for the hole on the opposite side. (Both knots should be visible on the front side of riser).

8. Finished riser with bungee attached

Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 Rev. 06/17#59504276