Wilbur Curtis Company ALP1GT, ALP3GTR, ALP3GTL, ALP5GT, ALP10GT General Manual
FIND OUT MORE
ON
THE WEB.
WILBURCURTIS.COM
Installation Instructions,
Service & Warranty Information
Revised: Sept 2002
Models Included
••
• ALP1GT
••
••
• ALP3GTR
••
••
• ALP3GTL
••
••
• ALP5GT
••
••
• ALP10GT
••
C
ISO 9001 REGISTERED
ALPHA 1GT
DRAFT COPY
Not Released. This Version Exists as File No.
I:\DIAGRAMS\FRANK\FX-134.p65
DIGITDIGIT
DIGIT
DIGITDIGIT
WILBUR CURTIS COMPANY Montebello, CA 90640
FOR THE LATEST SPEC INFORMATION GO TO WWW.WILBURCURTIS.COM
AL DECANTER BREWING SYSTEMAL DECANTER BREWING SYSTEM
AL DECANTER BREWING SYSTEM
AL DECANTER BREWING SYSTEMAL DECANTER BREWING SYSTEM
•
FF
INDIND
F
IND
INDIND
FF
THETHE
ONON
THE
ON
THETHE
ONON
WILBURWILBUR
WILBUR
WILBURWILBUR
OUTOUT
OUT
OUTOUT
CURCUR
CUR
CURCUR
MOREMORE
MORE
MOREMORE
WEBWEB
WEB
WEBWEB
TIS.COMTIS.COM
TIS.COM
TIS.COMTIS.COM
..
.
..
WW
W
WW
ILBURILBUR
ILBUR
ILBURILBUR
C C
C
C C
URTISURTIS
URTIS
URTISURTIS
C C
C
C C
OMPOMP
OMP
OMPOMP
ANYANY
ANY
ANYANY
, I, I
, I
, I, I
NCNC
NC
NCNC
..
.
..
Alpha Generation 3 - Decanter Brewer Instructions
Models Included
••
• ALP1GT
••
••
• ALP3GTR
••
••
• ALP3GTL
••
••
• ALP5GT
••
••
• ALP10GT
••
WARNING HOT LIQUID,
Scalding may occur.
Avoid splashing.
CAUTION: CAUTION:
CAUTION: Please use
CAUTION: CAUTION:
this setup procedure
this brewer. Failure to follow the
instructions can result in injury or
the voiding of the warranty.
is not rated for hot water.
before attempting to use
CAUTION: CAUTION:
CAUTION: DO NOT
CAUTION: CAUTION:
connect this brewer to
hot water. The inlet valve
Important Safeguards/Conventions
This appliance is designed for commercial use. Any servicing other than cleaning and maintenance should be performed by an
authorized Wilbur Curtis service center.
• Do NOT immerse the unit in water or any other liquid
• To reduce the risk of fire or electric shock, do NOT open top or rear panel. No user serviceable parts inside. Repair should
be done only by authorized service personnel.
• Keep hands and other items away from hot parts of unit during operation.
• Never clean with scouring powders, bleach or harsh implements.
ConventionsConventions
Conventions
ConventionsConventions
WW
ARNINGS – ARNINGS –
W
ARNINGS –
WW
ARNINGS – ARNINGS –
Important Notes/Cautions – from the factoryImportant Notes/Cautions – from the factory
Important Notes/Cautions – from the factory
Important Notes/Cautions – from the factoryImportant Notes/Cautions – from the factory
Sanitation RequirementsSanitation Requirements
Sanitation Requirements
Sanitation RequirementsSanitation Requirements
YY
our Curtis our Curtis
Y
our Curtis
YY
our Curtis our Curtis
Following are the Factory Settings for your ALPHA™ G³
Coffee Brewing Systems:
Generally there will never be a reason to change your ADS programming. However, should you need to make slight adjustments to
meet your brewing needs, programming instructions are provided later in this manual.
Equipment to be installed to comply with applicable federal, state, or local plumbing/electrical codes having jurisdiction.
SETUP STEPSSETUP STEPS
SETUP STEPS
SETUP STEPSSETUP STEPS
The unit should be level (left to right and front to back), located on a solid counter top. Connect a water line from the water filter to the
brewer. NOTE: Some type of water filtration device must be used to maintain a trouble-free operation. (In areas with extremely hard
water, we suggest that a sedimentary and taste & odor filter be installed.) This will prolong the life of your brewing system and
enhance coffee quality.
1. A 3/8” NPT x 1/4” Flare elbow has been supplied for water line connection. Use tubing sized sufficiently to provide a minimum of
1.0 GPM.
2. Connect the unit to an appropriate electrical power circuit.
3. Turn on the toggle (STANDBY/ON) switch behind the unit. The heating tank will start to fill. When the water level in the tank rises
to the correct volume, the heating elements will energize automatically. With ADS Systems there is no danger of element burnout
caused by an empty tank.
4. The heating tank will require 20 to 30 minutes to reach operating temperature (200°F) as indicated by the READY-TO-BREW
indicator light.
5. Prior to brewing, dispense 12 ounces of hot water through the hot water faucet.
6. Brew a cycle of at least 12 ounces, to purge the water lines of any air that may be trapped after filling.
ADS System is FADS System is F
ADS System is F
ADS System is FADS System is F
• Brew • Brew
• Brew
• Brew • Brew
• Brew • Brew
VV
• Brew
V
• Brew • Brew
VV
• •
WW
armer Setting on HIGH with Quality armer Setting on HIGH with Quality
•
W
armer Setting on HIGH with Quality
• •
WW
armer Setting on HIGH with Quality armer Setting on HIGH with Quality
System Requirements:
The National Sanitation Foundation requires the following water connection:
1. A quick disconnect or additional coiled tubing (at least 2x the depth of the unit) so that the machine can be moved
for cleaning underneath.
2. In some areas an approved backflow prevention device may be required between the brewer and water supply.
TT
o help ao help a
T
o help a
TT
o help ao help a
TT
emperaempera
ture = 200°Fture = 200°F
T
empera
ture = 200°F
TT
emperaempera
ture = 200°Fture = 200°F
olume = Set to dispensing vessel requirements (60 oz)olume = Set to dispensing vessel requirements (60 oz)
olume = Set to dispensing vessel requirements (60 oz)
olume = Set to dispensing vessel requirements (60 oz)olume = Set to dispensing vessel requirements (60 oz)
• •
WW
aa
ter Sourceter Source
•
W
a
ter Source 20 – 90 PSI (Minimum Flow Rate of 1 GPM)
• •
WW
aa
ter Sourceter Source
• Electrical:• Electrical:
• Electrical: See attached schematic for standard model or visit www.wilburcurtis.com for your model.
• Electrical:• Electrical:
void personal injurvoid personal injur
void personal injur
void personal injurvoid personal injur
actoractor
y Pre-Set and Ready Pre-Set and Read
actor
y Pre-Set and Read
actoractor
y Pre-Set and Ready Pre-Set and Read
TT
imer OFFimer OFF
T
imer OFF
TT
imer OFFimer OFF
yy
y
yy
y to Go… Right from the Carton.y to Go… Right from the Carton.
y to Go… Right from the Carton.
y to Go… Right from the Carton.y to Go… Right from the Carton.
C
ISO 9001 REGISTERED
WILBUR CURTIS COMPANY
Montebello, CA 90640
BREWING INSTRBREWING INSTR
BREWING INSTR
BREWING INSTRBREWING INSTR
1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button). Ready-to-Brew should be displayed.
2. Place empty decanter (not included with Alpha brewer) on warmer.
3. Place filter in brewcone.
4. Pour ground
coffee into
brewcone.
UCTIONSUCTIONS
UCTIONS
UCTIONSUCTIONS
5. Position
brewcone into
brew rails.
FOR THE LATEST SPECIFICATIONS AND INFORMATION GO TO
WWW.WILBURCURTIS.COM
6. Press Brew
button.
1
Loading...