Wilbur Curtis WR-2 Service Manual

Instructions, Airpot Rack Assembly

Wire airpot racks are easy to assemble. These racks are available in two and three airpot widths. Racks
can be combined to lock together and can be configured as two, three, four, five or six airpot groups.
Two-wide airpot racks are shown throughout these instructions; the three-wide assembly is identical
except for Attaching Legs, page 2.

PARTS INCLUDED:

SIGN HANGER

LABEL HOLDER

DRIP TRAY

Securing the Back

1

CROSS BRACE

BUTTRESSES

FOLDING LEGS

2

AIRPOT RACK
ASSEMBLY

ROTATE HINGED
BACK TO UPRIGHT
POSITION

3

ROTATE BUTTRESS DOWN TO
FRONT OF FRAME.

HOOK BUTTRESS ON TOP
BAR IN EYE-HOOK AND

ROTATE DOWNWARD.

4

INSERT DOWNTURNED FRONT
OF BUTTRESS INTO HOLE ON
FRAME.

Note: At this point, airpot rack may be used as a single level group of airpots of two or three across.

CONTINUED . . . . OVER

WILBUR CURTIS CO., INC.
6913 Acco St., Montebello, CA 90640-5403 USA
Phone: [phone] Fax: [phone]

Technical Support Phone: [phone] (M-F 5:30A - 4:00P PST) E-Mail: [e-mail]
Web Site: www.wilburcurtis.com

FOR THE LATEST SPECIFICATION INFORMATION GO TO WWW.WILBURCURTIS.COM

Attaching the Legs

1

HOLD RACK UP, HOOK LEGS
ON FRAME (2nd BAR FROM
END ON 2-WIDE RACKS, 3rd
BAR FROM END ON 3-WIDE
RACKS), LEGS POINT
FORWARD

2

Attaching the Sign Hanger

1

INSERT BOTH ENDS
OF HANGER INTO
HOLES ON FRAME

3

LEGS INSTALLED

SPREAD AND ATTACH
BRACE TO LEGS

Place Drip Tray

2

HANGER GOES IN
ONE WAY ONLY

Hooking Racks Together

1 2

Attaching Label Holders

Label holders can be attached to the airpot rack in two places:

LABEL HOLDER ON
FRONT OF RACK

On the tall sign hanger that inserts into
the back side of the airpot rack.

On the front of the rack.

LABEL HOLDER ON
TALL SIGN HANGER

4/28/9 . 16.0 . ECN 10396 . rev E

4/09 F-3262 rev E