WIKA WICP-L100, WICP-M500, WICP-H10K Data sheet

Calibration Test Equipment
& Accessories

Pneumatic & Hydraulic Hand Pumps
Model’s WICP-L100, WICP-M500, WICP-H10K

Features

 Generate both pressure and vacuum

 Generate –27 “Hg to 100 or 600 psi,

model-dependent

 Generate hydraulic pressure from 0 to 10,000 psi

 Completely isolated vernier prevents heat transfer

from hand

WIKA Datasheet WICP-x

 Precision valve for bleed control

 Pneumatic pumps include user-friendly, field

serviceable, and replaceable check valves

 Ergonomic design makes it easy to pump, even

at high pressure

Description

WIKA pneumatic and hydraulic test pumps are high
performance hand operated pumps that allow the user to
generate both pressure and vacuum for precise testing of
pressure instrumentation including transmitters, pressure
switches, and pressure gauges.

The pneumatic pumps allow pressures in excess of 100
or 500 psi (model-dependent) to be generated with just a
few strokes of the pump. By changing the switching valve
to vacuum, a range of -27” Hg is available.

The WICP-H10K Hydraulic Pressure Test Pump works
with a variety of hydraulic fluids or even water to eas­ily generate test pressures up to 10,000 psi (700 Bar). It
uses a unique fully adjustable stroke control to allow for
fast priming or filling of test systems, and then switching
as needed to a smaller stroke for easier pumping at high
pressure.

Model WICP-L100

Model WICP-M500

Model WICP-H10K

All pumps features NPT connections for ease of use.
See specifications for details.

In addition to the bare pump, all pump models are offered
in kit form with a hard sided carrying case and a flexible
connection hose with appropriate fittings.

The output pressure of all pumps can be fine tuned
using the vernier control. A precision needle valve
allows controlled venting for exacting pressure calibration
requirements.

WIKA Datasheet WICP_x · 02/2009

Page 1 of 2

Specifications (0 °C to +50 °C, unless otherwise noted)

Model

Parameter WICP-L100 WICP-M500 WICP-H10K

Operating Pressure Range -12 to 100 psi -12 to 600 psi 0 to 10,000 psi

Maximum Working Pressure 150 psi 750 psi 10,000 psi

Connection 1, 1/8” FNPT port 1, 1/4” FNPT (top) 2, 1/4” FNPT (top and side)
1, 1/8” FNPT (side) 1, 1/8” FNPT Port (for use
w/Press. Relief Valve Only)

Compatibility air air most hydraulic fluids
and oils and water

WICP-L100 Pneumatic Pump Kit

Ordering information

Pressure gauge model / Nominal size / Scale range / Size of connection / Optional extras required

Specifications and dimensions given in this leaflet represent the state of engineering at the time of printing.
Modifications may take place and materials specified may be replaced by others without prior notice.

WICP-H10K Pneumatic Pump Kit (shown with CPG 1000)

WIKA Datasheet WICP_x · 02/2009Page 2 of 2

WIKA Instrument Corporation

1000 Wiegand Boulevard
Lawrenceville, GA 30043
Tel [phone] Toll-free 1-888-WIKA-USA
Fax [phone]
E-Mail [e-mail]
www.wika.com