Page 1
User’s instructions
The Bravo Series
B2X / BXP
In-the-ear
Page 2
2 3
Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
On-O switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Volume control (optional on some models) . . . . . 6
Telecoil (M-T-MT) . . . . . . . . . . . . . . . . . . . . . . . . . 8
Change/insertion of battery . . . . . . . . . . . . . . . .10
Recommended battery type . . . . . . . . . . . . . . . . 12
Left/right identification . . . . . . . . . . . . . . . . . . . 13
Keeping the hearing aid clean . . . . . . . . . . . . . . 14
Important . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
When not in use . . . . . . . . . . . . . . . . . . . . . . . . . 16
Caring for your hearing aid . . . . . . . . . . . . . . . . 17
There’s only one way . . . . . . . . . . . . . . . . . . . . . 19
In case of malfunction . . . . . . . . . . . . . . . . . . . . 20
Troubleshooting guide . . . . . . . . . . . . . . . . . . . .21
Introduction
Your Widex Bravo hearing aid is a very intricate,
high precision electronic unit. It has been carefully designed to withstand years of wear, under the
varying conditions the typical user finds themselves in each day. However, your hearing aid
may be damaged if exposed to extreme conditions, severe blows, or general neglect.
To get full satisfaction from the quality and the
performance we have built into your new Widex
hearing aid, please handle it with care, and read
and follow the instructions carefully.
At the back of this manual you will find a troubleshooting guide, which will help you in situations
where your hearing aid does not perform according to your expectations.
Before placing the hearing aid in your ear, make
sure the battery is correctly inserted and that the
aid is switched on.
We hope you will be pleased with your new Widex
hearing aid!
Page 3
4 5
1. Microphone opening
2. Volume control (optional)
3. Red dot: right
Blue dot: left.
Serial number
The first two digits
in the serial number
indicate the year
your instrument
was manufactured
4. Wax guard
5. On-off switch
6. Nail grip
6.
5.
4.
3.
2.
1.
On-O switch
The battery compartment cover
also functions as an On-Off
switch. The hearing aid is
turned on when the cover is in
its normal position, and off
when the cover is pushed away
from the microphone opening.
Please remember to switch
the hearing aid off when it
is not in use for a lengthy
period, or to remove the battery.
Page 4
6 7
Volume control
(optional on some models)
Your hearing aid may be provided with a digital volume
control, shaped like a small
lever.
Push the lever upwards to
raise the volume. Push the
lever downwards to lower
the volume. Use short touches for minor corrections of the volume. Faster adjustments are obtained by keeping the lever pressed for some seconds.
When you raise the volume, you will hear a beeptone for each step the volume is raised. When the
maximum adjustment level is reached, a steady
tone will sound until you release the lever.
When you lower the volume, you will hear a deeper beep-tone for each step the volume is lowered.
When the minimum adjustment level is reached,
a steady tone will sound until you release the lever.
Bravo is equipped with a computer which has
been designed to adjust its sound automatically
in accordance with the sound environment around
you. Several thousand times per second, Bravo
analyzes the surroundings and tailors its sound
accordingly. Therefore, with this digital instrument you only need to adjust the volume to obtain
an as natural and comfortable sound as possible.
Any adjustment of the automatic volume setting
will be cancelled when your hearing aid is turned
off. Therefore, you must adjust the volume again,
if desired, each time you turn the hearing aid on.
Important: If the volume in your hearing aid is
too loud or too weak, or if you would like any further information, consult the hearing healthcare
professional where you received your hearing aid.
Page 5
8 9
Telecoil (M-T-MT)
Switch to “T”: Your
hearing aid is equipped
with a telecoil. You can activate it by pressing the
battery compartment cover briefly once (for ap-
proximately 1 second).
Bravo will signal the change by making one brief
beep-tone.
Listening via the telecoil “T” can be useful e.g.
when telephoning and with loop systems. A loop
system or magnetic field device can be fitted to a
TV or radio. Some public places such as churches,
theaters, cinemas and lecture rooms are already
equipped with a loop system, but you can always
ask if in doubt. On some telephones, the magnetic
field is inadequate, in which case the “M” position
should be used. If you are not sure your phone is
hearing aid compatible, consult your hearing
healthcare professional.
Switch back to “M”: If you wish to listen via the
microphone again (normal use), press the battery
compartment cover brief ly again. Bravo will signal the change by making one brief beep-tone.
Switch to “MT”: If you activate “MT” (microphone/telecoil) on your hearing aid, you can listen
via the telecoil while still hearing the sounds in
your surroundings (e.g. when watching TV while
still wanting to hear the doorbell or other sounds).
To switch from “M” (microphone) or from “T” (telecoil) to “MT” (microphone/telecoil) give the battery compartment cover a long press (for approx.
3 seconds). Two brief beep-tones indicate the
change to “MT” position.
Back to “M”: To revert to the “M” (microphone)
position, press the battery compartment cover (a
short or long press) once.
Page 6
10 11
Change/insertion of battery
Always turn the hearing aid off
before lifting the cover for access to the battery compartment.
Clean the new battery carefully
with a dry cloth to remove any
sticky residue before inserting.
The battery is placed correctly
when the plus (+) sign on the
battery is upwards (visible). If
the battery compartment cover
does not close easily, the battery
is incorrectly inserted.
When changing batteries, make
sure to hold the hearing aid over
a table, or to be in a carpeted
room, to make it easier to find a dropped battery.
Exhausted battery: If you hear four rapid beeptones while wearing your hearing aid, it is an indication that you should exchange the battery as
soon as possible, as the battery is nearly exhausted. Once the battery is totally exhausted, the
hearing aid will be completely silent.
Never let an exhausted battery remain in the
hearing aid. Exhausted batteries may leak, which
could damage your hearing aid.
Page 7
12 13
Recommended battery type
Bravo B2X and BXP use the Zinc Air battery type
312.
Some letters may be printed on the battery in addition to type 312.
This environmentally friendly type of battery has
about twice the lifetime of a mercury battery
when treated correctly. The battery can be stored
up to two years, as long as the sealing label is not
removed. Therefore, do not remove the label until
just before inserting the battery in the hearing
aid. Once inserted, the battery will start functioning after a few seconds. Operate your hearing aid
with the same battery until it is exhausted.
On occasion, a new battery may be exhausted because it was not sealed properly. If your hearing
aid does not work after you have replaced the battery, try inserting a different new battery.
Left/right identification
If you are wearing hearing aids on both ears
(which is highly recommendable if you have a
hearing loss on both ears), and you want to make
sure you are placing them correctly, you can arrange with your hearing healthcare professional
to have colored dots on the hearing aids (red dot =
right, blue dot = left).
Page 8
14 15
Keeping the hearing aid clean
Never wash your Bravo hearing aid in water. Instead, clean your hearing aid daily with a soft
cloth to keep the outside clean from residue, wax
etc.
If wax has gathered around the sound outlet this
should be removed with the small brush. It is important for the performance of the hearing aid
that the sound outlet is never blocked.
Your hearing aid may be equipped with a white
CeruSTOP wax guard mounted in the sound outlet. The wax guard prevents earwax from working
its way into the sound canal and blocking the passage of sound into your ear. Keeping your hearing
aid free of wax also helps minimize service and
repairs.
If your hearing aid is equipped with the CeruSTOP wax guard, you should also have received a
special wax guard user’s instructions. Please read
these instructions carefully.
Do not insert any pointed objects into the
sound outlet. This could damage the loudspeaker in the hearing aid!
Important
Please be sure to keep your hearing aid and its
accessories out of the reach of children, who may
place them in their mouths.
Keep batteries out of children’s reach and discard
used batteries carefully.
Do not change batteries in front of children or let
them see where you keep your supply.
Never put batteries in your mouth for any reason
and never let a child obtain a battery or place it in
their mouth.
In case of ingestion, contact your physician immediately and The National Button Battery In-
gestion Hotline at: (202) 625-3333.
Widex hearing aids are made of a modern non-allergenic material. Still, in rare cases skin irritation can occur. If you notice skin irritation in or
around your ear or ear canal, contact your hearing healthcare professional.
The use of hearing aids can lead to the formation
of earwax plugs in your ear canal, which can temporarily reduce your hearing ability. If you suspect that a plug has formed in your ear, contact
your ear doctor.
Page 9
16 17
When not in use
When your hearing aid is not in use, it should be
placed in the small case, which you can easily carry in a pocket or purse.
Please do not expose your hearing aid to excessive heat, such as leaving it on a window sill, near
a radiator or near a car window.
Caring for your hearing aid
With proper care, your hearing aid will give you
years of reliable service. Here are some things
you can do to prolong the life of your hearing aid:
• Treat your hearing aid as the valuable object that it is: with care.
• Keep it in its case in a cool, dry location
where it cannot be reached by children or
pets.
• Never expose it to extreme temperatures or
high humidity.
• Do not wear your hearing aid during shortwave diathermy, x-ray, or similar radiation
treatments.
• Some types of radiation from, for example,
NMR and CT scanners, can damage your
hearing aid. Always remove your hearing
aid for these, or similar types of scannings.
• Other types of radiation from, for example,
room surveillance equipment, burglar
alarms, radio equipment, and cellular telephones, are weaker and will not damage
your hearing aid, but they can cause noise or
distortion in your hearing aid.
Page 10
18 19
• Do not wear your aid in the shower or swimming, or when using a hair dryer, hair spray,
or other sprays.
• Switch your hearing aid off when it is not in
use. Should you not use it for a day or more,
take out the battery to avoid battery leakage.
• Always insert the battery as described on p.
10. If you feel the battery needs to be forced
into the drawer, check to see if it is upside
down.
• Widex hearing aids are not certified for use
in mines or other areas with explosive gases.
There’s only one way
Your hearing aid does not restore normal hearing,
but it will help you to hear and understand what
other people are saying and to enjoy many other
sounds. So don’t give up. The learning process will
take time, but millions of experienced users can
testify that the results are worth the effort.
There are no short cuts by which you can obtain
immediate and full benefit from your hearing aid.
Only consistent and determined practice will give
you the maximum results from your hearing aid.
It takes time getting used to “hearing” again and
to having “something” in your ear. Your ear may
even become a little sore at first, but that will
pass.
The sooner you become accustomed to wearing
the hearing aid every day and all day long, the
sooner you will succeed. Take the time and effort.
Hearing more out of life is worth it!
Page 11
20 21
In case of malfunction
Should your hearing aid be completely or periodically dead, try the following before consulting
your hearing healthcare professional:
• Change the battery and make sure the new
battery is correctly inserted.
• Make sure the hearing aid is switched on.
• Check if there is wax in the sound outlet.
See cleaning instructions p. 14.
• See the Troubleshooting guide p. 21-22.
Never try to open or repair
the hearing aid yourself
Troubleshooting guide
Symptom Cause Possible remedy
Dead Not turned on Turn it on
Battery low / dead Replace battery.
Insert battery
correctly
Poor battery
contacts
Clean battery
contacts with a
cotton swab
Blocked wax
guard
Clean/exchange
wax guard
The microphone is
not activated
Press the battery
cover briefly or
turn the hearing
aid off and on
again
Intermittent
sound
Battery contacts
dirty
Clean contacts
On-Off switch
dirty
Move On-Off
switch several
times
Page 12
22 23
Symptom Cause Possible remedy
Not loud
enough
Earwax blockage
in your ear
See your
physician
Change in hearing See your hearing
healthcare
professional
Whistles Hearing aid loose Remove and
reinsert
Page 13
Printed by HTO / 11-04
9 514 0006 041 #02
¡9 514 0006 001X¤ ¡#02y¤
Reorder # CIB45/1004
Loading...