Whittemore Enterprises Push Cut TPLO Saw Operating Manual

Operating manual

Push Cut TPLO Saw

1



g

TABLE OF CONTENTS

Pa

e
Introduction 3
Product configuration 3
Operation and use 4
Cleaning and sterilization 8
Technical specifications 9
Troubleshooting 9

Notice

Please read the entire manual prior to using the Whittemore battery operated
push cut TPLO saw.

For service or repair, contact Whittemore Enterprises at 909-980-2452 or 800-999-2452.

2



INTRODUCTION:

 Always inspect the components before and after use for identifying any

damage. Do not use the damaged part until it is repaired or replaced if
damage is observed.



Verify sterility prior to use. Do not use if not sterilized.





The hub and blade should be securely fixed to the main unit.



 Test and check the saw movement and sharpness of the blade prior to use.



The battery should not be sterilized at high temperature and/or high pressure.

Do not leave the battery in the saw for an extended period of time. Remove
the battery immediately if there is something wrong with the power during
surgery.



 Explosion hazard if batteries are exposed to flames. Properly dispose of used

batteries.



Stop using this device immediately if the main unit gets hot or makes an

abnormal sound. Contact your distributor and return the saw for repair.

 Optimum speed is 16000r/min. Damage to the bone can occur if the speed is

too high, and cutting time will increase if speed is too low.

PRODUCT CONFIGURATION:

This device is composed of the main unit, battery, and battery charger.



Fig.1 Structure of main unit

1. Rotating head 2. Power switch 3. End cover 4. Knob switch

3

