White-Westinghouse SGR231HS1, SGR231HS0, SGR231HQ1, SGR231HQ0 Owner’s Manual
OPERATING INSTRUCTHONS
TEM PERATU RA
CALOR BAJO
o
CAkOR ALTO oO o SIN CALOR
Before Operating Your Dryer
Read your dryer Owner's Guide. It has
important safety and warranty information. It
also has many suggestions for best drying results.
To reduce the risk of fire, electric
shock, or injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS in your dryer Owner's
Guide before operating this appliance.,.
Operating Steps
Read Drying Procedures inyour Owner's Guide.
tt explains these operating steps in detail.
1. Prepare items for drying°
ENCENDIDO
AUTOSECADO
©
3. Load the dryer. If desired, add a dryer fabric
softener sheet.
4. Close the dryer door.
5. Set Temperatura control.
6. Turn cycle selector to desired setting.
7. Start dryer. Push the ENCEDIDO (Start
Button) for 2 seconds.
8. Remove items immediately and hang or
fold.
9.Clean lint screen after every road.
TIEMPO
DE 8ECADO
90
80
70
6O
50
ENFRI AMIENTO
MENOS SECO
MAS SECO
100
10 m
20 o
O
30 40
Temperature Selection
Always follow directions on fa bric care labels.
To avoid fire hazard, do not use
heat to dry items containing feathers or down,
foam rubber, plastics, or similarlytextured, rubber-
like materials. Use SIN CALOR setting only.
The CALOR ALTO (HIGH HEAT) and CALOR
BAJO (LOW HEAT) temperature settings may
be used with any cycle setting The SIN
CALOR (NO HEAT) setting can be used only
in the Timed Dry cycle.
SIN CALOR (No Heat) setting tumbles the load
without heat. Use Sin Calor to freshen clothing,
pillows or blankets, or to dust draperies.
2. Check that lint screen is clean and in
place.
Printed in U.S.A. P/N 134330400 (0311)
TEM PERATU RA
CALOR BAJO
o
CALOR ALTO eO e SIN CALOR
Cycle Selection
Turn cycle selector clockwise to desired cycle
and setting.
Each cycle ends with a cool down period. The heat
automatically turns off and the load continues to
tumble for 5-10 minutes. This reduces wrinkling
and makes items easier to handle during unloading.
Drying time varies depending on load size,
dampness of load and fabric type. Room
temperature and humidity, type of installation
and electrical voltage or gas pressure can also
affect drying time.
Timed Dry Cycle
This cycle provides up to 100 minutes of drying
time at the temperature selection of your
choice.
ENCENDIDO AUTOSECABO
Auto Dry Cycle
This cycle is best for items of similar fabric, weight
and construction.
Drying time is determined automatically at the
temperature selection of your choice.
® For items requiring more drying time, set the
cycle selector on More (Mas).
® For items requiring less drying time, set cycle
selector on Less(Menos).
3]EMPO
DE 8ECADO
90
8O
7O
6O
5O
ENFRIAMIENTO
MENOSSECO
MAS SECO
I0
20 ®
100
O
30 40
Energy Saving Tips
® Keep the lint screen clean and exhaust the
dryer correctly.
Sort laundry properly and select proper
temperature and cycle settings. Choose an
automatic dry cycle whenever possible for
accurate drying time.
® Dry only full loads. Single items and small loads
usually take longer to dry.
o Avoid overloading, adding wet items to a
partially dry load, and overdrying.
o Dry one load after another to take advantage
of a warm dryer.
® Opening the door needlessly causes warm air
to escape, which prolongs drying time.
® If possible, use the dryer on low humidity days.
® Install the dryer in an area where the room
temperature is at least 45°F (7°C).
P/N 134330400 (03!1)
Loading...