QUICK START
GOLDMASTER
OWNER’S GUIDE
®
24k
GOLD NUGGET DETECTOR
with XGB Technology
©2018 White’s Electronics, Inc.
All rights reserved
P/N 621-0566
1-800-547-6911
White’s Electronics, Inc.
1011 Pleasant Valley Rd.
Sweet Home, OR 97386
whiteselectronics.com
GOLDMASTER
®
24k
ASSEMBLY
FEATURES
1 Attach the lower rod to the
search coil using the washers,
bolt, and nut
2 Assemble the 3 rod sections
to best t your body
3 Carefully wrap and secure the cable
around the sha of the detector
4 Connect the coil cable to the back of the pod
5 Insert the battery pack (the NiCd pack may need to charge overnight)
6 Insert headphones to the back of the detector
1
2
4
3
5
DISPLAY/CONTROLS
Target ID #
Higher number,
Better chance of gold
Beep Mode On
Iron Cancel On
Volume Level
SAT/Theshold Level
Audio Mode
SAT +/-
Volume +/-
Threshold +/-
Iron Cancel
Disc LO/HI
®
Ground Grab/Exit Setting Selection
Visual Target ID
Ground strength in
Ground Scan mode
Backlight On
TracLock On
Power On/
Ground Scan
Adjust other settings
Pinpoint (non-motion)
6
Sensitivity
Off
Backlight
TracLock
Sensitivity
SENSITIVITY - Set the sensitivity at a level that does not result in
false signals from the ground. Very strong ground may result in the
symbol on screen and a loud sound - this means the sensitivity is too
high.
GROUND BALANCE - With the default setting, the detector will use
XGB to automatically ground balance. Tap to lock the ground
balance to the current setting. Tapping when the ground balance is
locked will update the current ground setting to what is under the coil.
GROUND SCAN - Hold to put the detector into Ground Scan mode.
The top bar displays the ground strength and the two digit numbers
display the ground type (phase). Useful for tracing paystreaks.
IRON CANCEL - Tap to silence hot rocks, trash and mineral
changes in both audio modes. Hold to select the Iron Cancel setting
(1 bar is default). Note that this setting may decrease the detector’s
sensitivity to very small gold, but is necessary in difficult ground
conditions.
VOLUME and THRESHOLD - Tap to adjust the volume with the up
and down buttons. Hold to adjust the threshold with the up and
down buttons (“th” displays on screen). Set these to a comfortable level
for your hearing and preference.
AUDIO MODE - With the displayed on screen, the detector is in
“BEEP” audio mode (high tone = good target, low tone = bad target).
The default setting (without on screen) is a traditional All-Metal
audio mode with greater sensitivity to small targets.
SAT - SAT can smooth out ground inconsistencies. Hold to adjust it
(“Sa” displays on screen, 2 is the default setting).
PINPOINT - Hold for non-motion pinpoint mode. In difficult
ground this mode may be affected by mineralization.
BACKLIGHT - Tap to enable the backlight (this reduces battery life).
FREQUENCY SHIFT - Hold when turning the detector on to shift
frequency (useful when there is EMI). Power off to save the selection.
FACTORY RESET - Hold when turning the detector on to perform a
factory reset.
NOTE: Black REGULAR text = button TAP,
Blue ITALIC text = button HOLD
GOLDMASTER®
24k
XGB TECHNOLOGY
WARRANTY
XGB TECHNOLOGY is a patent-pending automatic ground balance
system. It is purpose-built for operating a high-frequency VLF gold
nugget detector in the worst ground conditions.
Traditional VLF detectors struggle to balance rapidly changing
ground mineralization. Historically this has been where Pulse
Induction machines fared much better.
With XGB technology, the Goldmaster 24k is able to track small
changes in soil composition as well as longer-term shifts in both
ground phase and strength. This allows it to operate in ground that
traditional VLFs struggle in.
Users have extended control over the range of XGB in the
Goldmaster’s All-Metal mode. Simply enable Iron Cancel to
expand the ground filter in moderate soils. In very challenging soil
conditions, hold the Iron Cancel button and select the 2-bar setting
for maximum performance in variable ground.
SPECIFICATIONS
Detector Type Gold Nugget/Prospecting
Frequency 48kHz
Weight 3.6 lbs with batteries
Length 45 inches to 55 inches, Assembled
Batteries 8aa and Rechargeable Included
If within two years (24 months) from the original date of purchase, your White’s
detector fails due to defects in either materials or workmanship, White’s will
repair or replace, at its option, all necessary parts without charge for parts or labor.
Simply return the complete detector to the Dealer where you purchased it or
to your nearest Authorized Service Center. The unit must be accompanied by a
detailed explanation of the symptoms of the failure. You must provide proof of
the date of purchase before the unit is serviced under warranty.
This is a transferable manufacturer warranty that covers the metal detector for
two years from the original date of purchase, regardless of the current owner.
Items excluded from the warranty are non-rechargeable batteries, accessories that
are not standard equipment, shipping and handling costs outside the continental
USA, special delivery costs (Air Freight, Next Day Air, 2nd Day Air, packaging
service, etc.) and all shipping and handling costs inside the continental USA 90
days after purchase.
Only authorized service centers can make repairs. This warranty does not
cover damage caused by accident, misuse, neglect, alterations, modifications,
unauthorized service, or prolonged exposure to corrosive compounds including salt. Duration of any implied warranty (e.g., merchantability and fitness for
a particular purpose) shall not be longer than the stated warranty. Neither the
manufacturer nor the retailer shall be liable for any incidental or consequential
damages.
Some states do not allow limitations on the length of implied warranties or the
exclusion of incidental or consequential damages. Therefore, the above limitations may not apply to you. In addition, the stated warranty provides specific legal
rights and you may have other rights, which vary from state to state.
The forgoing is the only warranty provided by White’s as the manufacturer of
your metal detector. Any “extended warranty” period beyond two years, which
may be provided by a Dealership or other third party on your metal detector, may
be without White’s authority, involvement, and consent, and may not be honored
by White’s Electronics, Inc
Battery Life 20-40 hrs
Search Coil 6x10 dd and 6” Concentric Included
IP Rating IP 54 (Rain/Dust Resistant)
Audio Speaker or 1/4” Headphone
Ground Balance XGB and TracLock
Warranty 2 Year Transferrable
Unique Features Ground Scan, All-Metal Disc.
Optional Coils GM24k Series
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is
subject to the following conditions.
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by White’s Electronics could void your
authority to operate this product.
Loading...