White Knight WM105M, WM126M Instruction Manual

Washing Machine Instruction Manual

Please read this instruction manual carefully before you use this product

White Knight

WM105M
WM126M

P.02

P.03

This instructionmanual includes importantinformation regarding theinstallation,
operation andmaintenance of thismachine. Please readthis manual carefullyto
ensure theproper operation ofthis washing machineand extend itsworking life.
Any warrantyshall not applyif problems orlosses have arisenfrom the user'sfailure
to observethe warnings mentionedin the installationand operation instructions.
Please keepall documents ina safe placefor future reference.If you haveany doubt,
please contactthe nearest authorisedservice centre ordealer.

- Ifyou plan todispose of thismachine, please complywith the localwaste disposal regulations.
Cut off the power cordso that itcan not bereused. Remove thedoor so thatchildren or animals
can notbe trapped inthe machine.

- Donot use excessivedetergent.

- Decontaminantand bleach shouldonly be usedto pre-treat stainson clothes whenabsolutely
necessary.

Environmental Protection

Contents

Notes

Safety Precautions

-Packaging materials maybe dangerous tochildren. Please keepall packaging materials
(plastic bags,foams, etc) awayfrom children.

-Washingmachines should notbe installed in very wet rooms or roomsthat

contain explosiveor caustic gases.

-Ensure that thewater and electricaldevices are connectedby a qualifiedtechnician in
accordance withthe manufacturer's instructionsand local safetyregulations.

-Before operating thismachine, all packagingand transport boltsmust be removed.
Otherwise, thewashing machine maybe seriously damagedwhilst washing theclothes

(refer topage 6 “Removingthe Transport Bolts”).

-Before washing clothesfor the firsttime, the washingmachine must beoperated for one
cycle withoutany clothes inthe drum (referto page 14“Washing Clothes for theFirst Time”).

-This washing machineis for indooruse only.

-Remove the plugfrom the socketbefore cleaning ormaintenance.

-Make sure thatall pockets areemptied.

-Sharp and rigiditems such ascoins, brooches, nails,screws or stones,etc, may causeserious
damage tothe machine.

-Remove the plugand turn off the water supplyafter use.

-Please check whetherthe water inthe drum hasbeen drained beforeopening the door.
Please donot open thedoor if thereis any watervisible.

-Pets and childrenmay climb intothe machine. Checkthe drum beforeevery operation.

-The glass doormay be veryhot during operation.Keep children andpets away fromthe machine

during operation.

-This machine isnot intended foruse by persons(including children) withreduced physical,
sensory ormental capabilities, orlack of experienceor knowledge, unlessthey have beengiven
supervision orinstruction concerning useof the machineby a personresponsible for theirsafety.

-Children should besupervised to ensurethat they donot play withthe machine.

-Do not tryto repair themachine yourself. The machinemay be damagedor more troublesome
repair workmay be causedand even dangerousoperation may takeplace if itis repaired byany
inexperienced orunqualified staff.

-If the plug(power cord) isdamaged, it shouldonly be replacedby the manufactureror their
service agent.

-Ensure that thesupply voltage andfrequency are identicalto those ofthe washing machine.

-Do not useany socket witha rated currentless than thatof the washingmachine.

-Do not removethe plug withwet hands.

Before Operating this Machine

Safety Warnings

Safety Precautions……………………………………………………3
Overview ofthe Washing Machine…………………………………..5
Installation Instructions……………………………………………….6
Operating Instructions…………………………………………………9

Checklist andPreparation before Washing Clothes………….10
View of theControl Panel…………………………………………13
Program Selection…………………………………………………14

Tableof Washing Programs………………………………………16
Maintenance……………………………………………………………17
Troubleshooting………………………………………………………..20
Appendix………………………………………………………………..22
TechnicalSpecification……………………………………………….23

P.04

P.05

Safety Precautions

Overview of Washing Machine

Care when Washing Clothes

Protecting the Machine

Care during Machine Handling

-This machine should be connected to the mains cold water supply.

-Your washing machine is only for home use and is designed for textiles suitable for
machine washing.

-Flammable, explosive or toxic solvents are forbidden. Gasoline and alcohol, etc,

should not be used as detergents. Please only use detergents that are suitable for
automatic washing machines.

-It is forbidden to wash carpets.

-Be careful of scalding when the washing machine drains hot water.

-Never refill the water by hand during the wash cycle.

-After the program has finished, please wait for 2 minutes before opening the door.

-Please remember to disconnect the water and electricity when not using the washing

machine.

-Do not climb up or sit on the top cover of the machine.

-Do not lean against the machine door.

-Please do not close the door with excessive force. Check that there is not excessive

laundry in the drum.

The transport bolts must be reinstalled to the machine by a suitable person.

-The accumulated water should be drained from the machine.

-Handle the machine carefully. Never hold protruding parts of the machine whilst lifting.

The machine door should not be used as a handle during conveyance.

-To ensure your safety the plug must be inserted into an earthed 13AUK socket.

Check carefully that the socket is properly and reliably earthed.

-This machine must only be repaired by an authorised service agent and only authentic

parts used.

-Notes on disposal:

This symbol on the product indicates that it must not be discarded as general
household waste. Instead it should be handed over to the applicable collection
point for the recycling of electrical and electronic equipment. Disposal must be
carried out in accordance with local environmental regulations for waste disposal.

Transport Hole Plug

Inlet Pipe C

Detergent Drawer

Control Panel

Door

Outlet Hose

Power Plug

Service Panel

Detergent Drawer

Outlet Hose Support

P.06

P.07

Installation Instructions

3.Loosen the lock nut with a spanner and turn the foot by hand until it contacts the floor.
Hold the foot with one hand and fasten the nut against the cabinet with a spanner.

4.Press the four top corners again to check that the feet have been adjusted properly.
If the machine is still unstable repeat steps 2 and 3.

5.Put a solid cylinder (e.g. pop can) on the top cover of the washing machine in the left,
right, front and back positions. If it rolls then the machine is not level. The rolling direction
is the direction of the ground surface. The two legs in this direction need to be raised
at the same time until the washing machine is level. Once the machine is level ensure
that all the nuts are locked tight.

Connect the inlet pipe as indicated in the figure.
This machine only has a cold water inlet.
The water inlet pipe should be connected to
a ¾” threaded water tap

1. Connect the end of the pipe, with an elbow,
to the water inlet valve on the rear of the machine.
Tighten the nut clockwise.

2. Connect the other end of the inlet pipe to the
water tap.

Turn on the tap and ensure that there is no water
leakage.

There are three possible ways to connect the outlet hose to a suitable drain.

1. Position the outlet hose into a sink.

Inlet Pipe Connection

Installing the Inlet Pipe

Installing the Outlet Hose

Unpacking the Washing Machine

Unpack the washing machine and check that there is no transport damage.
Ensure that all the items (as shown on page 5) are included in the enclosed bag.
If there is any damage to the washing machine during transportation or any items
are missing, please contact your retailer immediately.

The packaging materials of this machine may be dangerous to children.
Please dispose of them properly in accordance with the local regulations.
Please do notthrow the packaging materials away with general household waste.

Before using the washing machine the transport bolts
must be removed from the rear of the machine.
Please take the following steps to remove the bolts:

1. Loosen all 4 bolts with a spanner and remove them.

2. Stop the holes with the transport hole plugs provided.

3. Keep the transport bolts for future use.

The washing machine must be installed in a location with the following characteristics:

-Rigid, dry and level surface (if not level please refer to the following section “Adjusting the Feet”)

-Avoid direct sunlight

-Room temperature above 0°C

-Away from sources of heat
Ensure that the washing machine is not standing on the power cord.
Do not install the washing machineon a carpeted floor.

1.When positioning the washing machine please check
that all the feet are fully screwed into the cabinet. If not,
please turn them to their original positions and tighten
the nuts with a spanner.

2.After positioning the washing machine, press all four
corners on the top of the washing machine in sequence.
If the washing machine is not stable when being pressed,
this foot should be adjusted.

Disposal of the Packaging Materials

Removing the Transport Bolts

Selecting the Location

Adjusting the Feet

Installation Instructions