White Knight CF099M, CF142M Instruction Manual

CHEST FREEZER
CF099M CF142M
Important: Please read these instructions thoroughly before using your appliance. Keep them in a safe place for future reference.
SAFETY INFORMATION
This chest freezer is intended for normal household use.
The appliance is designed for indoor use only.
Wait at least 2 hours before first powering up the appliance to allow the
cooling system to settle after transportation.
Do not sit, stand or place any other heavy items on top of the appliance.
Do not allow children to play with the appliance to avoid the risk of
entrapment and suffocation.
Do not use mechanical, electrical or chemical methods to speed up the
defrost process.
Do not store liquids in glass containers in the freezer as these may
shatter.
Do not store flammable materials such as alcohol, gasoline, LP gas or
glue, etc, in the freezer.
This appliance contains the refrigerant isobutene (R600a) which is
flammable.
If the refrigeration circuit should become damaged, avoid naked flames
and sources of ignition. Thoroughly ventilate the room in which the appliance is situated.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or suitably qualified person, in order to avoid a hazard.
Any electrical work required to install the appliance should be carried out
by a qualified person.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Do not position the appliance near a heat source.
Ensure that sufficient space is left around the appliance to provide
adequate ventilation.
Do not use single/multiple adapters or extension cables.
This appliance is designed to be freestanding only and should not be built-
in.
INSTALLATION
It is recommended that 2 people unpack and install the appliance.
The appliance must be positioned on a firm, level, solid floor, which is
strong enough to support the freezer when it is fully loaded.
Ensure that a minimum of 15cm of space is left at the back and sides of
the appliance, to allow for proper ventilation.
Ensure that there is enough space above the appliance for the lid to fully
open.
Locate the appliance away from sources of heat and out of direct sunlight.
Do not install the appliance in a moist or wet environment.
This appliance is suitable for use in an ambient temperature of 10 to 43°C.
WARNING: This appliance must be earthed.
Any electrical work that is required to install the appliance must be carried
out by a qualified electrician.
The freezer should be powered from a 220-240V 50Hz supply.
It is recommended that the socket is still accessible after the freezer has
been installed.
OPERATION
Before using your Chest Freezer
1. Ensure that the appliance has been installed as recommended and that it is level.
2. Clean the inside of the freezer compartment (see ‘Care and Maintenance’)
3. Ensure that the appliance has been left for a minimum of 2 hours before switching on the power, to allow the refrigeration system to stabilise.
4. Insert the plug into a socket and switch on the supply.
5. Run the chest freezer for 2 – 3 hours to allow the compartment to get down to temperature, before placing food in the freezer compartment.
Caution: When the compressor first starts up it may produce some background noise. This is normal and will reduce as the cooling system operates.
Loading...
+ 5 hidden pages